TPS7H1101A-SP
TPS7H1101A-SP
www.ti.com
SLVSDW6C – APRIL 2017 – REVISED APRIL 2021
SLVSDW6C – APRIL 2017 – REVISED APRIL 2021
TPS7H1101A-SP 1.5-V to 7-V Input, 3-A, Radiation-Hardened LDO Regulator
PMOS pass element configuration. It operates over
1 Features
a wide range of input voltage, from 1.5 V to 7 V
while offering excellent PSRR. The TPS7H1101A-SP
features a precise and programmable foldback current
limit implementation with a very-wide adjustment
range. To support the complex power requirements of
FPGAs, DSPs, or microcontrollers, the TPS7H1101A-
SP provides enable on and off functionality,
programmable soft start, current sharing capability,
and a Power Good open-drain output.
•
5962R13202 (1)
:
– Radiation hardness assurance (RHA) qualified
up to total ionizing dose (TID) 100 krad(Si)
– ELDRS-free: 100 krad(Si)
– Dose rate: 10 mrad(Si)/s
– Single event latch-up (SEL) immune to
LET = 85 MeV-cm2/mg
– SEB and SEGR immune to
LET = 85 MeV-cm2/mg
Device Information
– SET/SEFI onset threshold > 40 MeV-cm2/mg(2)
PART NUMBER(1)
GRADE
PACKAGE
•
Specifically designed to always upset low
to avoid damage to critical downstream
component
KGD Flight Grade
RHA 100 krad(Si)
5962R1320202V9A
Flight Grade RHA
100 krad(Si)
5962R1320202VXC
TPS7H1101HKR/EM
TPS7H1101AHKR/EM
TPS7H1101SPEVM
16-Pin CFP
– SET/SEFI cross-section plot(2)
Ultra-low VIN range: 1.5 V to 7 V
3-A maximum output current
Current share/parallel operation to provide up to
6-A output current
Stable with ceramic output capacitor
±2% accuracy over line, load, and temperature
Programmable soft start through external capacitor
Input enable across all input voltages and power-
good output for power sequencing
Ultra-low dropout LDO voltage:
62 mV at 1 A (25°C), VOUT = 1.8 V
Low noise:
20.33 µVRMS, VIN = 2 V, VOUT = 1.8 V at 3 A
PSRR: over 45 dB at 1 kHz
Excellent load/line transient response
Foldback current limit
See the Design and development tab
Thermally-enhanced CFP package, 0.4° C/W RθJC
9.60 mm × 11.00 mm
Weight: 1.55 g(4)
Engineering
•
•
•
Modules(3) (5)
Engineering
Modules(3)
Ceramic
Evaluation Board
EVM
•
•
•
•
(1) For all available packages, see the orderable addendum at
the end of the data sheet.
(2) See Radiation Report (SNAA257) for details.
(3) These units are intended for engineering evaluation only.
They are processed to a noncompliant flow (that is, no
burn-in, and so forth) and are tested to a temperature
rating of 25°C only. These units are not suitable for
qualification, production, radiation testing or flight use. Parts
are not warranted for performance over the full MIL specified
temperature range of –55°C to 125°C or operating life.
(4) Weight is accurate to ±10%.
•
•
•
•
•
•
•
(5) TPS7H1101HKR/EM with device Date Code newer than 1705
is equivalent to TPS7H1101AHKR/EM using rev A silicon.
2 Applications
TPS7H1101A-SP
5 V
Power
V
•
Space satellite point of load supply for FPGAs,
microcontrollers, ASICs, and data converters
Radiation-hardened low-noise linear regulator
power supply for RF, VCOs, receivers, and
amplifiers
IN
Good
C
IN
R
CS
COMP
EN
3.3 V
C
•
V
OUT
CS
R
PCL
T
OUT
Soft
Start
Feed
Back
R
PCL
GND
•
•
•
•
•
Clean analog supply requirements
Command and data handling (C&DH)
Optical imaging payload
Radar imaging payload
Satellite electrical power system (EPS)
R
B
C
SS
Copyright © 2017, Texas Instruments Incorporated
Typical Application Circuit
3 Description
The TPS7H1101A-SP is an improved version of
the TPS7H1101-SP allowing the use of the enable
feature across the entire input voltage range. It is a
radiation-hardened LDO linear regulator that uses a
An IMPORTANT NOTICE at the end of this data sheet addresses availability, warranty, changes, use in safety-critical applications,
intellectual property matters and other important disclaimers. PRODUCTION DATA.
Product Folder Links: TPS7H1101A-SP
Copyright © 2021 Texas Instruments Incorporated
Submit Document Feedback
1