CSP-12
QFN-10
TPS61054, TPS61055
www.ti.com
SLUS760–SEPTEMBER 2007
HIGH POWER WHITE LED DRIVER
2-MHz SYNCHRONOUS BOOST CONVERTER WITH STANDARD LOGIC INTERFACE
1
FEATURES
DESCRIPTION
2
•
Four Operational Modes
–
–
–
Torch and Flash up to ILED = 700 mA
Voltage-Regulated Boost Converter: 5.0 V
Shutdown: 0.3 μA (typ)
The TPS6105x device uses
a
high-frequency
synchronous-boost topology with constant current
sink to drive single white LEDs. The device uses an
inductive fixed-frequency PWM control scheme using
small external components, minimizing input ripple
current.
•
•
•
•
•
•
•
•
•
Total Solution Circuit Area < 25 mm2
Up to 96% Efficiency
Integrated LED Turn-On Safety Timer
Zero Latency TX-Masking Input
Integrated Low Light Dimming Mode
LED Disconnect During Shutdown
Open/Shorted LED Protection
Over-Temperature Protection
The 2-MHz switching frequency allows the use of
small and low-profile 2.2-μH inductors. To optimize
overall efficiency, the device operates with only a
250-mV LED feedback voltage.
The TPS6105x device not only operates as a
regulated current source, but also as a standard
voltage-boost regulator. This additional operating
mode can be useful to supply other high-power
devices in the system, such as a hands-free audio
power amplifier, or any other component requiring a
supply voltage higher than the battery voltage.
Available in a 12-Pin NanoFree™ (CSP) and
10-Pin QFN Packaging
APPLICATIONS
•
The LED current or the desired output voltage can be
programmed via two logic signals (MODE0/1). To
simplify flash synchronization with the camera
Camera White LED Torch/Flash for Cell
Phones, Smart-Phones and PDAs
General Lighting Applications
Audio Amplifier Power Supply
•
•
module, the device offers
a
trigger pin
(FLASH_SYNC) for fast LED turn-on time.
When the TPS6105x is not in use, it can be put into
shutdown mode, reducing the input current to 0.3 μA
(typ). During shutdown, the LED pin is high
impedance to avoid leakage current through the LED.
TPS61054
4.7 mm
L
+ BATTERY
SW
SW
VOUT
INDUCTOR
2.2 mH
C1
COUT
AVIN
10 mF
L1
P
CIN
LED
SENSE
P
P
PGND
LED
MODE1
MODE0
Tx-TOFF
PGND
FLASH_SYNC
PGND
PGND
P
C2
AGND
LED ANODE
Figure 1. Typical Application
Figure 2. Typical PC-Board Layout
1
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
2
NanoFree, PowerPAD are trademarks of Texas Instruments.
PRODUCT PREVIEW information concerns products in the
formative or design phase of development. Characteristic data and
other specifications are design goals. Texas Instruments reserves
the right to change or discontinue these products without notice.
Copyright © 2007, Texas Instruments Incorporated