TPS61050
CSP-12
QFN-10
TPS61052
www.ti.com
SLUS525–MARCH 2007
1.2-A HIGH POWER WHITE LED DRIVER
2-MHz SYNCHRONOUS BOOST CONVERTER WITH I2C COMPATIBLE INTERFACE
FEATURES
DESCRIPTION
•
Four Operational Modes
The TPS6105x device is based on a high-frequency
synchronous-boost topology with constant current
sink to drive single white LEDs. The device uses an
inductive fixed-frequency PWM control scheme using
small external components, minimizing input ripple
current.
–
–
Torch and Flash up to ILED = 1200 mA
Voltage-Regulated Boost Converter:
4.5/5.0/5.25 V
–
Shutdown: 0.3 µA (typ)
•
•
•
•
•
•
Total Solution Circuit Area < 25 mm2
The 2-MHz switching frequency allows the use of
small and low profile 2.2-µH inductors. To optimize
overall efficiency, the device operates with only a
250 mV LED feedback voltage.
Up to 96% Efficiency
I2C-Compatible Interface up to 400 kbps
Integrated LED Turn-On Safety Timer
Zero Latency TX-Masking Input (TPS61050)
The TPS6105x device not only operates as a
regulated current source, but also as a standard
voltage-boost regulator. This additional operating
mode can be useful to supply other high-power
devices in the system, such as a hands-free audio
power amplifier, or any other component requiring a
supply voltage higher than the battery voltage (refer
to TPS61052).
Hardware Voltage Mode Selection Input
(TPS61052)
•
•
•
•
•
•
Integrated ADC for LED VF Monitoring
Integrated Low Light Dimming Mode
LED Disconnect During Shutdown
Open/Shorted LED Protection
For highest flexibility, the LED current or the desired
output voltage can be programmed via an I2C
Over-Temperature Protection
Available in a 12-Pin NanoFree™ (CSP) and
10-Pin QFN Packaging
compatible
interface.
To
simplify
flash
synchronization with the camera module, the device
offers a trigger pin (FLASH_SYNC) for fast LED
turn-on time.
APPLICATIONS
•
Camera White LED Torch/Flash for Cell
Phones, Smart-Phones and PDAs
Audio Amplifier Power Supply
When the TPS6105x is not in use, it can be put into
shutdown mode via the I2C-compatible interface,
reducing the input current to 0.3 µA (typ). During
shutdown, the LED pin is high impedance to avoid
leakage current through the LED.
•
4.7 mm
TPS61050
L
+ BATTERY
SW
SW
VOUT
INDUCTOR
2.2 mH
C1
COUT
AVIN
10 mF
L1
P
CIN
LED
SENSE
P
P
PGND
LED
SCL
SDA
2
I C I/F
GPIO
PGND
FLASH_SYNC
P
PGND
PGND
C2
AGND
LED ANODE
Figure 1. Typical Application
Figure 2. Typical PC-Board Layout
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of Texas
Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
NanoFree, PowerPAD are trademarks of Texas Instruments.
PRODUCTION DATA information is current as of publication date.
Products conform to specifications per the terms of the Texas
Instruments standard warranty. Production processing does not
necessarily include testing of all parameters.
Copyright © 2007, Texas Instruments Incorporated