TPS54678
www.ti.com
SLVSBF3 –JUNE 2012
2.95 V to 6 V INPUT, 6 A OUTPUT, 2 MHz, SYNCHRONOUS STEP DOWN SWITCHER WITH
INTEGRATED FET ( SWIFT™)
Check for Samples: TPS54678
1
FEATURES
DESCRIPTION
TPS54678 device is a full featured 6 V, 6 A,
synchronous step down current mode converter with
two integrated MOSFETs.
2
•
Two 12 mΩ (typical) MOSFETs for High
Efficiency 6 A Continuous Output Current
•
•
200 kHz to 2 MHz Switching Frequency
TPS54678 enables small designs by integrating the
MOSFETs, implementing current mode control to
reduce external component count, reducing inductor
size by enabling up to 2 MHz switching frequency,
and minimizing the IC footprint with a small 3 mm x 3
mm thermally enhanced QFN package.
0.6 V ±1% Voltage Reference Over
Temperature (-40°C to 150°C)
•
•
•
•
•
Synchronizes to External Clock
Start up with Pre-Biased Voltage
Power Good Output
TPS54678 provides accurate regulation for a variety
of loads with an accurate ±1% Voltage Reference
(VREF) over temperature.
Adjustable Slow Start and Sequencing
Cycle-by-Cycle Current Limit and Hiccup
Current Protection
Efficiency is maximized through the integrated 12 mΩ
MOSFETs. Using the enable pin, shutdown supply
current is reduced by disabling the device.
•
•
Adjustable Input Voltage UVLO
Thermally Enhanced 16-Pin 3 mm x 3 mm QFN
(RTE)
The output voltage startup ramp is controlled by the
soft start pin that can also be configured for
sequencing or tracking. Monotonic startup is achieved
with pre-biased voltage. Under voltage lockout can be
increased by programming the threshold with a
resistor divider on the enable pin. An open drain
power good signal indicates the output is within 93%
to 105% of its nominal voltage.
APPLICATIONS
•
•
Low-Voltage, High-Density Power Systems
Point of Load Regulation for High Performance
DSPs, FPGAs, ASICs and Microprocessors
•
•
•
Broadband, Networking and Optical
Communications Infrastructure
Gaming, DTV and Set-Top Boxes
Cycle-by-cycle current limit, hiccup overcurrent
protection and thermal shutdown protect the device
during an overcurrent condition.
95
94
93
92
91
90
89
88
VIN
VIN
TPS54678
CI
CBOOT
BOOT
EN
LO
VOUT
PH
PWRGD
CO
R1
VOUT = 1.8 V
Fsw = 500 KHz
DCR = 7.5 mΩ
87
86
85
VIN = 3.3 V
VIN = 5 V
VSENSE
GND
SS/TR
RT/CLK
COMP
1
2
3
4
5
6
R2
Current (A)
G020
CSS
R3
RT
C1
1
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
2
SWIFT, PowerPAD are trademarks of Texas Instruments.
PRODUCTION DATA information is current as of publication date.
Products conform to specifications per the terms of the Texas
Instruments standard warranty. Production processing does not
necessarily include testing of all parameters.
Copyright © 2012, Texas Instruments Incorporated