ꢀ
ꢁ
ꢂ
ꢃ
ꢄ
ꢅ
ꢆ
ꢆ
ꢇ
ꢈ
ꢆ
ꢉ
ꢀ ꢁꢂꢃ ꢄ ꢅ ꢆ ꢋ ꢇꢈ ꢆ ꢉ
ꢀ
ꢀ
ꢀ
ꢁ
ꢁ
ꢁ
ꢂ
ꢂ
ꢂ
ꢃ
ꢃ
ꢃ
ꢄ
ꢄ
ꢄ
ꢅ
ꢅ
ꢅ
ꢆ
ꢆ
ꢆ
ꢊ
ꢄ
ꢅ
ꢇ
ꢇ
ꢇ
ꢈ
ꢈ
ꢈ
ꢆ
ꢆ
ꢆ
Typical Size
6,6 mm X 9,8 mm
www.ti.com
ꢀ
ꢁ
ꢂ
ꢃ
ꢄ
ꢅ
ꢆ
ꢃ
ꢇ
ꢈ
ꢆ
ꢉ
SGLS266D − OCTOBER 2004 − REVISED DECEMBER 2004
ꢋ
ꢇ
ꢌ
ꢀ
ꢍ
ꢂ
ꢅ
ꢘ
ꢇ
ꢌ
ꢎ
ꢏ
ꢓ
ꢁ
ꢔ
ꢐ
ꢚ
ꢀ
ꢕ
ꢉ
ꢅ
ꢘ
ꢇ
ꢑ
ꢍ
ꢔ
ꢐ
ꢀ
ꢀ
ꢁ
ꢚ
ꢐ
ꢛ
ꢀ
ꢕ
ꢂ
ꢑ
ꢒ
ꢀ
ꢏ
ꢚ
ꢓ
ꢜ
ꢔ
ꢝ
ꢕ
ꢚ
ꢍ
ꢀ
ꢏ
ꢞ
ꢍ
ꢐ
ꢘ
ꢂ
ꢎ
ꢖ
ꢐ
ꢓ
ꢠ
ꢗ
ꢁ
ꢘ
ꢙ
ꢎ
ꢀ
ꢎ
ꢀ
ꢎ
ꢏ
ꢟ
ꢂ
ꢝ
ꢀ
FEATURES
DESCRIPTION
(1)
D
D
D
Qualification in Accordance With AEC-Q100
Qualified for Automotive Applications
Customer-Specific Configuration Control Can
Be Supported Along With Major-Change
Approval
The SWIFT family of dc/dc regulators, the TPS54611,
TPS54612, TPS54613, TPS54614, TPS54615, and
TPS54616 low-input voltage high-output current
synchronous-buck PWM converters integrate all required
active components. Included on the substrate are true,
high-performance, voltage error amplifiers that provide
high performance under transient conditions; an
under-voltage-lockout circuit to prevent start-up until the
input voltage reaches 3 V; an internally and externally set
slow-start circuit to limit in-rush currents; and a power good
output useful for processor/logic reset, fault signaling, and
supply sequencing.
D
D
D
30-mΩ, 12-A Peak MOSFET Switches for High
Efficiency at 6-A Continuous Output Source
and Sink
0.9-V, 1.2-V, 1.5-V, 1.8-V, 2.5-V, and 3.3-V Fixed
Output Voltage Devices With 1% Initial
Accuracy
Internally Compensated for Easy Use and
Minimal Component Count
The TPS54611−6 devices are available in a thermally
enhanced 28-pin TSSOP (PWP) PowerPAD package,
which eliminates bulky heatsinks. Texas Instruments
provides evaluation modules and the SWIFT designer
software tool to aid in quickly achieving high-performance
power supply designs to meet aggressive equipment
development cycles.
D
Fast Transient Response
Wide PWM Frequency − Fixed 350 kHz,
550 kHz or Adjustable 280 kHz to 700 kHz
D
D
Load Protected by Peak Current Limit and
Thermal Shutdown
D
Integrated Solution Reduces Board Area and
Total Cost
Contact Texas Instruments for details. Q100 qualification data
availableon request.
(1)
APPLICATIONS
D
D
Low-Voltage, High-Density Systems With
Power Distributed at 5 V or 3.3 V
Point of Load Regulation for High
Performance DSPs, FPGAs, ASICs and
Microprocessors
D
D
Broadband, Networking and Optical
Communications Infrastructure
Portable Computing/Notebook PCs
These devices have limited built-in ESD protection. The leads should be shorted together or the device placed in conductive foam during
storage or handling to prevent electrostatic damage to the MOS gates.
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of Texas Instruments
semiconductor products and disclaimers thereto appears at the end of this data sheet.
PowerPAD and SWIFT are trademarks of Texas Instruments.
ꢁꢕ ꢍ ꢜꢐ ꢓ ꢀꢎ ꢍꢏ ꢜ ꢑꢀꢑ ꢡꢢ ꢣꢤ ꢥ ꢦꢧ ꢨꢡꢤꢢ ꢡꢞ ꢩꢪ ꢥ ꢥ ꢫꢢꢨ ꢧꢞ ꢤꢣ ꢬꢪꢭ ꢮꢡꢩ ꢧꢨꢡ ꢤꢢ ꢯꢧ ꢨꢫꢰ ꢁꢥ ꢤꢯꢪ ꢩꢨꢞ
ꢩ ꢤꢢ ꢣꢤꢥ ꢦ ꢨꢤ ꢞ ꢬꢫ ꢩ ꢡ ꢣꢡ ꢩ ꢧ ꢨꢡ ꢤꢢꢞ ꢬ ꢫꢥ ꢨꢱꢫ ꢨꢫ ꢥ ꢦꢞ ꢤꢣ ꢀꢫꢲ ꢧꢞ ꢎꢢꢞ ꢨꢥ ꢪꢦ ꢫꢢꢨ ꢞ ꢞꢨ ꢧꢢꢯ ꢧꢥ ꢯ ꢳ ꢧꢥ ꢥ ꢧ ꢢꢨꢴꢰ
ꢁꢥ ꢤ ꢯꢪꢩ ꢨ ꢡꢤ ꢢ ꢬꢥ ꢤ ꢩ ꢫ ꢞ ꢞ ꢡꢢ ꢵ ꢯꢤ ꢫ ꢞ ꢢꢤꢨ ꢢꢫ ꢩꢫ ꢞꢞ ꢧꢥ ꢡꢮ ꢴ ꢡꢢꢩ ꢮꢪꢯ ꢫ ꢨꢫ ꢞꢨꢡ ꢢꢵ ꢤꢣ ꢧꢮ ꢮ ꢬꢧ ꢥ ꢧꢦ ꢫꢨꢫ ꢥ ꢞꢰ
Copyright 2001−2004, Texas Instruments Incorporated