TPL51200 Series
3-A Sink and Source DDR Termination Regulator
Features
Description
◼
◼
◼
VIN Voltage: Support 2.5-V, 3.3-V and 5-V Power Rails
With the development of main processors in PCs and servers,
more and more source double-data-rate (DDR) memories are
required in the mainboard, where the input voltage becomes
lower and lower, and space limitation becomes higher and
higher.
VLDOIN Voltage Range: 1.1 V to 3.5 V
Flexible Input Voltage Tracking Directly from REFIN or
Through External Resistor Divider
3-A Sink and Source Current Capability for DDR
Termination
◼
◼
◼
◼
◼
◼
Integrated Power MOSFETs
The TPL51200 series devices are 3-A sink and source DDR
termination regulators specifically designed for the DDR
applications with heavy space limitation. The TPL51200 series
devices implement a fast load-transient response and only
requires a minimum output capacitance of 20 μF.
Output Remote Sensing
Fast Load-Transient Response
Open-Drain Power Good to Monitor OUT Regulation
Built in Soft-Start and UVLO, Current Limit and Thermal
Shutdown Protection
◼
Support DDR, DDR2, DDR3, DDR3L, Low Power DDR3
and DDR4 VTT Applications
The TPL51200 series devices support a remote-sensing
function and all power requirements for DDR VTT bus
termination. In addition, the TPL51200 series devices provide
an open-drain PG signal for VTT regulation indication and an
EN signal that can be used to discharge VTT for DDR
applications.
◼
◼
◼
Operating Temperature Range: –40°C to +125°C
Small Package with 3×3 DFN-10
Pb−Free and are RoHS Compliant
Applications
The TPL51200 series devices are available in the thermally
efficient 10-pin 3×3 DFN package with thermal pad, and support
the operating temperature range from –40°C to +125°C.
◼
Memory VTT Regulator for DDR, DDR2, DDR3, DDR3L,
Low Power DDR3 and DDR4
◼
◼
◼
Notebooks, Desktops, and Workstations
Servers, Networking equipment and Datacenters
Telecom and Base Station
Typical Application Schematic
10 kΩ
VDDQ = 1.2 V
1
REFIN
IN 10
VIN = 3.3 V
1 nF
4.7 μF
10 kΩ
100 kΩ
PG
9
8
PG Signal to I/O
VLDOIN = VDDQ = 1.2 V
2
LDOIN
10 μF
0.1 μF
GND
EN
TPL51200
7
6
Enable Signal
VTT = 0.6 V
3
4
OUT
10 μF
10 μF
10 μF
REFOUT
VTTREF = 0.6 V
0.1 μF
PGND
GND
5
SNS
www.3peak.com
Rev.A.1
1 / 18