5秒后页面跳转
TPIC1021DG4 PDF预览

TPIC1021DG4

更新时间: 2024-09-16 12:16:11
品牌 Logo 应用领域
德州仪器 - TI 网络接口电信集成电路电信电路光电二极管
页数 文件大小 规格书
18页 738K
描述
LIN Physical Interface

TPIC1021DG4 技术参数

是否无铅: 不含铅是否Rohs认证: 符合
生命周期:Not Recommended零件包装代码:SOIC
包装说明:SOIC-8针数:8
Reach Compliance Code:compliantECCN代码:EAR99
HTS代码:8542.39.00.01Factory Lead Time:1 week
风险等级:5.35Is Samacsys:N
JESD-30 代码:R-PDSO-G8JESD-609代码:e4
长度:4.9 mm湿度敏感等级:1
功能数量:1端子数量:8
收发器数量:1最高工作温度:125 °C
最低工作温度:-40 °C封装主体材料:PLASTIC/EPOXY
封装代码:SOP封装形状:RECTANGULAR
封装形式:SMALL OUTLINE峰值回流温度(摄氏度):260
认证状态:Not Qualified座面最大高度:1.75 mm
最大压摆率:2.5 mA标称供电电压:14 V
表面贴装:YES电信集成电路类型:INTERFACE CIRCUIT
温度等级:AUTOMOTIVE端子面层:Nickel/Palladium/Gold (Ni/Pd/Au)
端子形式:GULL WING端子节距:1.27 mm
端子位置:DUAL处于峰值回流温度下的最长时间:NOT SPECIFIED
宽度:3.9 mmBase Number Matches:1

TPIC1021DG4 数据手册

 浏览型号TPIC1021DG4的Datasheet PDF文件第2页浏览型号TPIC1021DG4的Datasheet PDF文件第3页浏览型号TPIC1021DG4的Datasheet PDF文件第4页浏览型号TPIC1021DG4的Datasheet PDF文件第5页浏览型号TPIC1021DG4的Datasheet PDF文件第6页浏览型号TPIC1021DG4的Datasheet PDF文件第7页 
TPIC1021  
LIN Physical Interface  
www.ti.com  
SLIS113COCTOBER 2004REVISED JULY 2005  
FEATURES  
Dominant State Timeout Protection on TXD  
Pin  
LIN Physical Layer Specification Revision 2.0  
compliant. Conforms to SAEJ2602  
Recommended Practice for LIN  
Wake-Up Request on RXD Pin  
Control of External Voltage Regulator (INH  
Pin)  
LIN Bus Speed up to 20 kbps  
ESD Protection to 12 kV (Human Body Model)  
on LIN Pin  
Integrated Pull-Up Resistor and Series Diode  
for LIN Slave Applications  
LIN Pin Handles Voltage from -40 V to +40 V  
Low EME (Electromagnetic Emissions), High  
EMI (Electromagnetic Immunity)  
Survives Transient Damage in Automotive  
Environment (ISO 7637)  
Bus Terminal Short-Circuit Protected for  
Short to Battery or Short to Ground  
Operation with Supply from 7 V to 27 V DC  
Thermally Protected  
Two Operation Modes: Normal and Low  
Power (Sleep) Mode  
Ground Disconnection Fail Safe at System  
Level  
Low Current Consumption in Low Power  
Mode  
Ground Shift Operation at System Level  
Wake-Up Available from LIN Bus, Wake-Up  
Input (External Switch) or Host MCU  
Unpowered Node Does Not Disturb the  
Network  
Interfaces to MCU with 5 V or 3.3 V I/O Pins  
D PACKAGE  
(TOP VIEW)  
RXD  
EN  
NWake  
TXD  
INH  
1
2
3
4
8
7
6
5
V
SUP  
LIN  
GND  
DESCRIPTION  
The TPIC1021 is the LIN (Local Interconnect Network) physical interface, which integrates the serial transceiver  
with wake up and protection features. The LIN bus is a single wire, bi-directional bus typically used for low-speed  
in-vehicle networks using baud rates between 2.4 kbps and 20 kbps.  
The LIN bus has two logical values: the dominant state (voltage near ground) represents a logic ‘0’ and the  
recessive state (voltage near battery) and represents logic ‘1’.  
In the recessive state the LIN bus is pulled high by the TPIC1021’s internal pull-up resistor (30k) and series  
diode, so no external pull-up components are required for slave applications. Master applications require an  
external pull-up resistor (1k) plus a series diode.  
The LIN Protocol output data stream on the TXD pin is converted by the TPIC1021 into the LIN bus signal  
through a current limited, wave-shaping low-side driver with control as outlined by the LIN Physical Layer  
Specification Revision 2.0. The receiver converts the data stream from the LIN bus and outputs the data stream  
via the RXD pin.  
In Low Power mode, the TPIC1021 requires very low quiescent current even though the wake-up circuits remain  
active allowing for remote wake up via the LIN bus or local wake ups via NWake or EN pins.  
The TPIC1021 has been designed for operation in the harsh automotive environment. The device can handle LIN  
bus voltage swing from +40 V down to ground and survive -40 V. The device also prevents back feed current  
through the LIN pin to the supply input in case of a ground shift or supply voltage disconnection. It also features  
under-voltage, over temperature, and loss of ground protection. In the event of a fault condition the output is  
immediately switched off and remains off until the fault condition is removed.  
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of Texas  
Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.  
PRODUCTION DATA information is current as of publication date.  
Copyright © 2004–2005, Texas Instruments Incorporated  
Products conform to specifications per the terms of the Texas  
Instruments standard warranty. Production processing does not  
necessarily include testing of all parameters.  

TPIC1021DG4 替代型号

型号 品牌 替代类型 描述 数据表
TPIC1021AQDRQ1 TI

完全替代

LIN PHYSICAL INTERFACE
TPIC1021DR TI

完全替代

LIN Physical Interface
TPIC1021D TI

完全替代

LIN Physical Interface

与TPIC1021DG4相关器件

型号 品牌 获取价格 描述 数据表
TPIC1021DR TI

获取价格

LIN Physical Interface
TPIC1021DRG4 TI

获取价格

LIN Physical Interface
TPIC1301 TI

获取价格

3-HALF H-BRIDGE GATE-PROTECTED POWER DMOS ARRAY
TPIC1301DW TI

获取价格

3-HALF H-BRIDGE GATE-PROTECTED POWER DMOS ARRAY
TPIC1301DWR TI

获取价格

2.25A, 60V, 0.275ohm, 6 CHANNEL, N-CHANNEL, Si, POWER, MOSFET, MS-013AD, PLASTIC, SOIC-24
TPIC1310 TI

获取价格

3-HALF H-BRIDGE GATE PROTECTED POWER DMOS ARRAY
TPIC1310KTR TI

获取价格

3-HALF H-BRIDGE GATE PROTECTED POWER DMOS ARRAY
TPIC1310KTS TI

获取价格

3-HALF H-BRIDGE GATE PROTECTED POWER DMOS ARRAY
TPIC1321L TI

获取价格

3-HALF H-BRIDGE GATE-PROTECTED LOGIC-LEVEL POWER DMOS ARRAY
TPIC1321LDW TI

获取价格

3-HALF H-BRIDGE GATE-PROTECTED LOGIC-LEVEL POWER DMOS ARRAY