36-72VDC IT
NPO
UTT
RAA
NGL
E DP
C-O
DCW
COE
NVR
ERTI
EN
R HT
AL'
FL
-BRICK
POWER MODULES 100-150 WATTS SINGLE & DUAL OUTPUT
TPDH100-48B-S&D SERIES
FEATURES:
ꢀ
ꢀ
ꢀ
ꢀ
ꢀ
ꢀ
ꢀ
SINGLE & DUAL OUTPUT
WIDE 2:1 INPUT RANGE
1500VDC ISOLATION
STANDARD HALF-BRICK PACKAGE
HIGH-EFFICIENCY POWER MODULE
UNDER-VOLTAGE LOCKOUT
DESIGNED TO MEET INTERNATIONAL
SAFETY STANDARDS
SPECIFICATION
INPUT SPECIFICATION
OUTPUT SPECIFICATION
Output Voltage: See Ratings Chart.
Output Current: See Ratings Chart.
Output Wattage: Typ. 100W continuous.
Line Regulation: Typ. 0.1%.
Load Regulation: Typ. ±1.0%.
Noise & Ripple: Typ. 100mV, peak to peak.
OVP: Built-in on main output.
Input Range: Wide 2:1 Input DC Range 36-72Vdc.
Input Voltage: Nominal 48Vdc.
Input Current: Typ. 2.65A full load and 0.03A no-load
@ 48Vdc nominal input.
Input Fuse: Use external fuse.
Inrush Current: Typ. 55A @ 75Vdc.
Input Filter: Pi-Network for EMI suppression.
Under-Voltage Protection (UVP): Lock-out activated at
34-35.5Vdc input.
Input Reflected Ripple Current: 40mA pk-pk @48 Vdc.
Isolation Voltage: 1,500Vdc input-output.
Remote On/Off: TTL/CMOS-Compatible input control.
Logic input reference to -Vin.
Adjustability: Factory set.
Overload Protection (OLP): Fully protected against
overload and short circuit. Typical 130% max. load.
Consult the factory for special OLP setting.
Logic [1]/Open(or 2.4Vdc above -Vin)=ON.
Logic [0]/Short(or 0~0.08Vdc above -Vin)=OFF.
GENERAL SPECIFICATION
Efficiency: Typ. 80%, various with input.
Switching Frequency: Fixed frequency 330K Hz.
Circuit Topology: 300K Hz. Forward Circuit.
Operating Temperature: -40 to +100°C (baseplate).
Storage Temperature: -40 to +100 °C.
Temperature Coefficient: 0.02%/°C.
Transient Response: Peak transient <100mV and recovers Humidity: Up to 95% RH, Non-Condensing.
within 1mS after 25% load-change.
Case: Aluminum baseplate.
Power Density: 36.0 Watts / Cubic inch.
Industrial Grade.
NOTE: (1) All measurements are at nominal input, full load, and +25°C unless otherwise spec.
(2) Line Regulation measured from High to Low Lines at full load.
(3) Load Regulation measured from Full-Load (F-L) to Half-Load(H-L)at nominal input.
(4) Correct fuse size by calculating the max. DC current drain at low Line input & adding 20-25% for desired fuse size.
TOTAL POWER INT'L Tel: 877-646-0900 Fax: 978-453-7395
ꢀ
Email: sales@total-power.com http://www.total-power.com
-1-
ꢀ