TPA2001D1
1-W FILTERLESS MONO CLASS-D AUDIO POWER AMPLIFIER
SLOS338B – SEPTEMBER 2000 – REVISED AUGUST 2002
PW PACKAGE
(TOP VIEW)
D
D
Modulation Scheme Optimized to Operate
Without a Filter
4 mm × 4 mm MicroStar Junior BGA and
TSSOP Package Options
1
2
3
4
5
6
7
8
16
15
14
13
12
11
10
9
INP
INN
SHUTDOWN
GAIN0
BYPASS
AGND
COSC
ROSC
D
1 W Into an 8-Ω Speaker (THD+N<1%)
D
<0.2% THD+N at 1 W, 1 kHz, Into an
8-Ω Load
GAIN1
V
DD
PV
PV
DD
OUTN
PGND
DD
D
Extremely Efficient Third Generation 5-V
Class-D Technology:
– Low-Supply Current (No Filter) . . . 4 mA
– Low-Supply Current (Filter) . . . 7.5 mA
– Low-Shutdown Current . . . 0.05 µA
OUTP
PGND
MicroStar Juniort (GQC) Package
(TOP VIEW)
– Low-Noise Floor . . . 40 µV
RMS
INP
AGND BYPASS
(No-Weighting Filter)
A2
A6
A7
A1
B1
C1
D1
– Maximum Efficiency Into 8 Ω, 75 – 85%
– 4 Internal Gain Settings . . . 6 – 23.5 dB
– PSRR . . . –77 dB
NC
COSC
ROSC
INN
SHUTDOWN
GAIN0
B7
C7
D7
E7
F7
G7
V
PV
PV
GAIN1
DD
DD
DD
D
D
Integrated Depop Circuitry
E1
F1
G1
PV
PV
OUTP
DD
DD
Short-Circuit Protection (Short to Battery,
Ground, and Load)
OUTN
PGND
description
(SIDE VIEW)
The TPA2001D1 is a 1-W mono bridge-tied-load
(BTL) class-D amplifier designed to drive a
speaker with at least 8-Ω impedance. The
amplifier uses TI’s third generation modulation
technique, which results in improved efficiency
and SNR. It also allows the device to be
NC – No internal connection, still requires a pad for the ball.
NOTE: The shaded terminals are used for thermal
connections to the ground plane.
connected directly to the speaker without the use of the LC output filter commonly associated with class-D
amplifiers (this will result in EMI which must be shielded at the system level). These features make the device
ideal for use in devices where high-efficiency is needed to extend battery run time.
The gain of the amplifier is controlled by two input terminals, GAIN1, and GAIN0. This allows the amplifier to
be configured for a gain of 6, 12, 18, and 23.5 dB. The differential input terminals are high-impedance CMOS
inputs, and can be used as summing nodes.
The class-D BTL amplifier includes depop circuitry to reduce the amount of turnon pop at power up, and when
cycling SHUTDOWN.
The TPA2001D1 is available in the 16-pin TSSOP and MicroStar Junior BGA packages that will drive 1 W of
continuous output power into an 8-Ω load. TPA2001D1 operates over an ambient temperature range of –40°C
to 85°C.
AVAILABLE OPTIONS
PACKAGED DEVICES
T
A
†
‡
TSSOP (PW)
TPA2001D1PW
GQC
TPA2001D1GQCR
–40°C to 85°C
†
‡
The PW package is available taped and reeled. To order a taped and reeled
part, add the suffix R to the part number (e.g., TPA2001D1PWR).
The GQC package is only available taped and reeled.
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
MicroStar Junior is a trademark of Texas Instruments.
Copyright 2002, Texas Instruments Incorporated
This document contains information on products in more than one phase
of development. The status of each device is indicated on the page(s)
specifying its electrical characteristics.
1
POST OFFICE BOX 655303 • DALLAS, TEXAS 75265