TLP715F
TOSHIBA PHOTOCOUPLER GaAℓAs IRED & PHOTO-IC
TLP715F
Isolated Bus Drivers
Unit in mm
High Speed Line Receivers
4.58±0.25
6 5 4
Microprocessor System Interfaces
The Toshiba TLP715F consists of a GaAℓAs light-emitting diode and an
integrated high-gain, high-speed photodetector. This unit is a 6-pin SDIP. The
TLP715F is 50% smaller than the 8-PIN DIP and meets the reinforced
insulation class requirements of international safety standards. Therefore the
mounting area can be reduced in equipment requiring safety standard
certification.
1
2 3
7.62±0.25
The detector has a totem pole output stage to provide both source and sink
driving. The detector IC has an internal shield that provides a guaranteed
common-mode transient immunity of 10 kV/μs.
The TLP715F is buffer logic type. For inverter logic type, the TLP718F is in
line-up.
Absolute maximum ratings and electrical characteristics are the same as in
the TLP715 technical data sheets.
1.27±0.2
0.4±0.1
0.75±0.25
11.7±0.3
11-5J101
TOSHIBA
11-5J101
z
z
z
z
z
z
z
z
Buffer logic output (totem pole output)
Weight:0.26 g(typ.)
Guaranteed performance over temperature : −40 to 100°C
Power supply voltage : 4.5 to 20 V
Input current: I
FLH
= 3mA (Max.)
/ t : 250 ns (Max.)
Switching time ( t
pLH pHL)
Pin Configuration (Top View)
Common-mode transient immunity : ±10 kV/μs (Min)
1:ANODE
2:N.C.
VCC
1
2
6
5
4
Isolation voltage : 5000 Vrms (Min)
UL recognized
UL1577, File No.E67349
3:CATHODE
4:GND
GND
z
z
c-UL recognized
CSA Component Acceptance Service No. 5A, File No.E67349
5:Vo (Output)
6:Vcc
3
SHIELD
Option (D4)
TÜV recognized / VDE under application : DIN EN60747-5-5
Maximum Operating Insulation Voltage : 1140Vpk
Schematic
I
CC
V
CC
Highest Permissible Over Voltage
: 8000Vpk
6
(Note) : When a EN60747-5-5 approved type is needed,
Please designate “Option(D4)”
I
F
Tr1
Tr2
1+
VF
3-
I
O
z
Construction Mechanical Rating
V
O
7.62 mm pitch
standard type
10.16 mm pitch
TLPXXXF type
5
Creepage Distance
Clearance
Insulation Thickness
7.0 mm (Min)
7.0 mm (Min)
0.4 mm (Min)
8.0 mm (Min)
8.0 mm (Min)
0.4 mm (Min)
GND
SHIELD
4
Truth Table
0.1 μF bypass capacitor must be
connected between pins 6 and 4.
Input
H
LED
ON
Tr1
Tr2
Output
ON OFF
OFF ON
H
L
OFF
L
1
2012-12-19