TLK110
www.ti.com
SLLS901A –DECEMBER 2011–REVISED FEBRUARY 2012
Industrial Temp, Single Port 10/100Mbs Ethernet Physical Layer
Transceiver
Check for Samples: TLK110
1 Introduction
1.1 Features
1
• Low Power Consumption: <205mW PHY and
275mW with Center Tap (Typical)
• Cable Diagnostics
• IEEE 1149.1 JTAG
• Error-Free Operation up to 150 Meters Under
Typical Conditions
• Programmable Fast Link Down Modes, <10µs
reaction time
• Fixed TX Clock to XI, with programmable phase
shift
• Integrated ANSI X3.263 Compliant TP-PMD
Physical Sublayer with Adaptive Equalization
and Baseline Wander Compensation
• Programmable LED Support Link, 10/100Mbs
Mode, Activity, and Collision Detect
• 3.3V MAC Interface
• 10/100Mbs Packet BIST (Built in Self Test)
• Bus I/O Protection - ±16kV JEDEC HBM
• Enable implementation of IEEE1588 Time
Stamping at the MAC
• 48-pin LQFP Package (7mm) × (7mm)
• HBM ESD protection on RD± and TD± of 16kV
• Auto-MDIX for 10/100Mbs
• Energy Detection Mode
• 25 MHz Clock Out
• MII and RMII Interfaces
• Serial Management Interface
• IEEE 802.3u MII
• IEEE 802.3u Auto-Negotiation and Parallel
Detection
1.2 Applications
• IEEE 802.3u ENDEC, 10Base-T
Transceivers and Filters
• IEEE 802.3u PCS, 100Base-TX Transceivers
•
•
•
Industrial Networks and Factory Automation
Motor and Motion Control
General Embedded Applications
1.3 Device Overview
The TLK110 is a single-port Ethernet PHY for 10Base-T and 100Base TX signaling. It integrates all the
physical-layer functions needed to transmit and receive data on standard twisted-pair cables. This device
supports the standard Media Independent Interface (MII) and Reduced Media Independent Interface
(RMII) for direct connection to a Media Access Controller (MAC).
The TLK110 is designed for power-supply flexibility, and can operate with a single 3.3V power supply or
with combinations of 3.3V and 1.5V power supplies for reduced power operation.
The TLK110 uses mixed-signal processing to perform equalization, data recovery, and error correction to
achieve robust operation over CAT 5 twisted-pair wiring. It not only meets the requirements of IEEE 802.3,
but maintains high margins in terms of cross-talk and alien noise.
1
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
PRODUCTION DATA information is current as of publication date. Products conform to
specifications per the terms of the Texas Instruments standard warranty. Production
processing does not necessarily include testing of all parameters.
Copyright © 2011–2012, Texas Instruments Incorporated