P r e l i m i n a r y D a t a s h e e t T L E 6 2 8 8 R
TLE 6288 R : Smart 6 Channel Peak&Hold Switch
Features
Product Summary
•
•
•
3 Channel high side with adjustable P&H current control
3 Channel high / low side configurable
Supply voltage
On resistance
Lowside clamping voltage Vcll (max) +55
Highside clamping voltage Vclh (max) -19
Peak current range
Hold current range
Peak time range
VS
4.5 – 5.5
V
Ω
V
V
A
A
Protection
Over Current (current limitation)
Overtemperature
RON 1-6 0.15
Overvoltage (active clamping)
•
•
Diagnosis
Ipk
Ihd
Ip
1.2 - 3.6
0.7 - 2
Over Current
Over Temperature
Open Load (Off-State)
0
- 3.6 ms
Short to Ground (Off-state, lowside configura-
tion)
Fixed off time range
Ifo
100 – 400 µs
Short to Vbb (Off-state, highside configura-
tion)
Interface and Control
16 Bit Serial Peripheral Interface (2bit/CH)
Device programming via SPI
Separate diagnosis output for each CH ( DIAG1 – 6)
General Fault Flag + Overtemperature Flag
Direct parallel control of all channels
P-DSO 36-12
General enable signal to control all channels simultaneously
Ordering Code:
• Low Quiescent Current
• Compatible with 3.3V and 5V Microcontrollers
• Electostatic discharge (ESD) protection of all pins
Application
• Solenoids, Relays and Resistive Loads
• Fast protected Highside Switching (PWM up to >10kHz)
• Peak and Hold Loads (valves, coils)
General description
Fault Reset VDO VCC
The TLE6288 R is a 6-channel (150mΩ)
Smart Multichannel Switch in SPT4 Tech-
CLKProg
DOUT 1
SOUT 1
Channel 1-3
nology. The IC has embedded protection,
IN 1
Highside 150 m
diagnosis and configurable functions.
Logic
DOUT 2
SOUT 2
Channel 1-3 are highside channels with
IN 6
Peak&Hold
Protection
Diagnosis
integrated charge pump and can be pro-
Configuration
DOUT 3 / VB
SOUT 3
grammed individually to do autonomous
DIAG 1
peak and hold current regulation with
PWM. Channel 4-6 (also with integrated
Current
DIAG 5
DOUT 4
SOUT 4
Regulation
charge pump) can be configured to work
as highside Switch or lowside Switch. This
IC can be used to drive standard automo-
tive loads in highside or lowside applica-
tions with switching frequencies up to
10kHz. In addition the TLE6288R can be
used to drive autonomously up to 3 induc-
tive Peak&Hold (valves, coils) loads with
programmable peak and hold current val-
ues.
DIAG 6
Channel 4 -6
Highside/ Lowside
150 mΩ
Overtemp.
DOUT 5
SOUT 5
SCLK
CS
SI
SO
Protection
Diagnosis
Charge-
pump
SPI
DOUT 6
SOUT 6
GND
FSIN
VCP
Vp2
Page 1
13.01.2003