5秒后页面跳转
TL16C2550IRHBG4 PDF预览

TL16C2550IRHBG4

更新时间: 2024-02-25 12:14:17
品牌 Logo 应用领域
德州仪器 - TI 先进先出芯片
页数 文件大小 规格书
47页 1091K
描述
1.8-V to 5-V DUAL UART WITH 16-BYTE FIFOS

TL16C2550IRHBG4 技术参数

是否无铅: 不含铅是否Rohs认证: 符合
生命周期:Active零件包装代码:QFN
包装说明:HVQCCN, LCC32,.2SQ,20针数:32
Reach Compliance Code:compliantHTS代码:8542.31.00.01
Factory Lead Time:6 weeks风险等级:5.73
其他特性:ALSO OPERATES AT 1.8V MINIMUM SUPPLY AT 10MHZ地址总线宽度:3
边界扫描:NO最大时钟频率:24 MHz
通信协议:ASYNC, BIT最大数据传输速率:0.1875 MBps
外部数据总线宽度:8JESD-30 代码:S-PQCC-N32
JESD-609代码:e4长度:5 mm
低功率模式:NO湿度敏感等级:2
串行 I/O 数:2端子数量:32
最高工作温度:85 °C最低工作温度:-40 °C
封装主体材料:PLASTIC/EPOXY封装代码:HVQCCN
封装等效代码:LCC32,.2SQ,20封装形状:SQUARE
封装形式:CHIP CARRIER, HEAT SINK/SLUG, VERY THIN PROFILE峰值回流温度(摄氏度):260
电源:1.8/5 V认证状态:Not Qualified
座面最大高度:1 mm子类别:Serial IO/Communication Controllers
最大压摆率:7.5 mA最大供电电压:5.5 V
最小供电电压:4.5 V标称供电电压:5 V
表面贴装:YES技术:CMOS
温度等级:INDUSTRIAL端子面层:Nickel/Palladium/Gold (Ni/Pd/Au)
端子形式:NO LEAD端子节距:0.5 mm
端子位置:QUAD处于峰值回流温度下的最长时间:NOT SPECIFIED
宽度:5 mmuPs/uCs/外围集成电路类型:SERIAL IO/COMMUNICATION CONTROLLER, SERIAL
Base Number Matches:1

TL16C2550IRHBG4 数据手册

 浏览型号TL16C2550IRHBG4的Datasheet PDF文件第2页浏览型号TL16C2550IRHBG4的Datasheet PDF文件第3页浏览型号TL16C2550IRHBG4的Datasheet PDF文件第4页浏览型号TL16C2550IRHBG4的Datasheet PDF文件第5页浏览型号TL16C2550IRHBG4的Datasheet PDF文件第6页浏览型号TL16C2550IRHBG4的Datasheet PDF文件第7页 
TL16C2550  
www.ti.com  
SLWS161DJUNE 2005REVISED OCTOBER 2006  
1.8-V to 5-V DUAL UART WITH 16-BYTE FIFOS  
FEATURES  
False-Start Bit Detection  
Programmable Auto-RTS and Auto-CTS  
Complete Status Reporting Capabilities  
In Auto-CTS Mode, CTS Controls Transmitter  
3-State Output TTL Drive Capabilities for  
Bidirectional Data Bus and Control Bus  
In Auto-RTS Mode, RCV FIFO Contents, and  
Threshold Control RTS  
Line Break Generation and Detection  
Internal Diagnostic Capabilities:  
Serial and Modem Control Outputs Drive a  
RJ11 Cable Directly When Equipment Is on  
the Same Power Drop  
– Loopback Controls for Communications  
Link Fault Isolation  
Capable of Running With All Existing  
TL16C450 Software  
– Break, Parity, Overrun, and Framing Error  
Simulation  
After Reset, All Registers Are Identical to the  
TL16C450 Register Set  
Fully Prioritized Interrupt System Controls  
Modem Control Functions (CTS, RTS, DSR,  
DTR, RI, and DCD)  
Up to 24-MHz Clock Rate for up to 1.5-Mbaud  
Operation With VCC = 5 V  
Available in 48-Pin TQFP (PFB), 32-Pin QFN  
(RHB), or 44-Pin PLCC (FN)(1) Packages  
Up to 20-MHz Clock Rate for up to  
1.25-Mbaud Operation With VCC = 3.3 V  
Pin Compatible with TL16C752B (48-Pin  
Package PFB)  
Up to 16-MHz Clock Rate for up to 1-Mbaud  
Operation With VCC = 2.5 V  
(1) Product Preview  
Up to 10-MHz Clock Rate for up to 625-kbaud  
Operation With VCC = 1.8 V  
APPLICATIONS  
In the TL16C450 Mode, Hold and Shift  
Registers Eliminate the Need for Precise  
Synchronization Between the CPU and Serial  
Data  
Point-of-Sale Terminals  
Gaming Terminals  
Portable Applications  
Router Control  
Cellular Data  
Factory Automation  
Programmable Baud Rate Generator Allows  
Division of Any Input Reference Clock by 1 to  
(216 - 1) and Generates an Internal 16 × Clock  
Standard Asynchronous Communication Bits  
(Start, Stop, and Parity) Added to or Deleted  
From the Serial Data Stream  
DESCRIPTION  
The TL16C2550 is a dual universal asynchronous  
receiver and transmitter (UART). It incorporates the  
functionality of two TL16C550D UARTs, each UART  
having its own register set and FIFOs. The two  
UARTs share only the data bus interface and clock  
source, otherwise they operate independently.  
Another name for the uart function is Asynchronous  
Communications Element (ACE), and these terms  
will be used interchangeably. The bulk of this  
document describes the behavior of each ACE, with  
the understanding that two such devices are  
incorporated into the TL16C2550.  
5-V, 3.3-V, 2.5-V, and 1.8-V Operation  
Independent Receiver Clock Input  
Transmit, Receive, Line Status, and Data Set  
Interrupts Independently Controlled  
Fully Programmable Serial Interface  
Characteristics:  
– 5-, 6-, 7-, or 8-Bit Characters  
– Even-, Odd-, or No-Parity Bit Generation  
and Detection  
– 1-, 1 1/2-, or 2-Stop Bit Generation  
– Baud Generation (DC to 1 Mbit/s)  
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of Texas  
Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.  
PRODUCTION DATA information is current as of publication date.  
Products conform to specifications per the terms of the Texas  
Instruments standard warranty. Production processing does not  
necessarily include testing of all parameters.  
Copyright © 2005–2006, Texas Instruments Incorporated  

与TL16C2550IRHBG4相关器件

型号 品牌 描述 获取价格 数据表
TL16C2550IRHBR TI 1.8-V to 5-V DUAL UART WITH 16-BYTE FIFOS

获取价格

TL16C2550IRHBRG4 TI 1.8-V to 5-V DUAL UART WITH 16-BYTE FIFOS

获取价格

TL16C2550PFB TI 2.5-V to 5-V DUAL UART WITH 16-BYTE FIFOS

获取价格

TL16C2550PFBG4 TI 1.8-V to 5-V DUAL UART WITH 16-BYTE FIFOS

获取价格

TL16C2550PFBR TI 2.5-V to 5-V DUAL UART WITH 16-BYTE FIFOS

获取价格

TL16C2550PFBRG4 TI 1.8-V to 5-V DUAL UART WITH 16-BYTE FIFOS

获取价格