5秒后页面跳转
TL032ACP PDF预览

TL032ACP

更新时间: 2024-11-10 22:42:11
品牌 Logo 应用领域
德州仪器 - TI 运算放大器放大器电路光电二极管
页数 文件大小 规格书
56页 885K
描述
ENHANCED-JFET LOW-POWER LOW-OFFSET OPERATIONAL AMPLIFIERS

TL032ACP 技术参数

是否无铅: 不含铅是否Rohs认证: 符合
生命周期:Active零件包装代码:DIP
包装说明:DIP-8针数:8
Reach Compliance Code:compliantECCN代码:EAR99
HTS代码:8542.33.00.01Factory Lead Time:1 week
风险等级:1.43Is Samacsys:N
放大器类型:OPERATIONAL AMPLIFIER架构:VOLTAGE-FEEDBACK
最大平均偏置电流 (IIB):0.0004 µA25C 时的最大偏置电流 (IIB):0.0002 µA
最小共模抑制比:75 dB标称共模抑制比:94 dB
频率补偿:YES最大输入失调电流 (IIO):0.0001 µA
最大输入失调电压:800 µVJESD-30 代码:R-PDIP-T8
JESD-609代码:e4长度:9.81 mm
低-偏置:YES低-失调:NO
微功率:YES负供电电压上限:-18 V
标称负供电电压 (Vsup):-5 V功能数量:2
端子数量:8最高工作温度:70 °C
最低工作温度:封装主体材料:PLASTIC/EPOXY
封装代码:DIP封装等效代码:DIP8,.3
封装形状:RECTANGULAR封装形式:IN-LINE
包装方法:TUBE峰值回流温度(摄氏度):NOT SPECIFIED
功率:NO电源:+-5/+-15 V
可编程功率:NO认证状态:Not Qualified
座面最大高度:5.08 mm最小摆率:1.5 V/us
标称压摆率:2.9 V/us子类别:Operational Amplifier
最大压摆率:0.56 mA供电电压上限:18 V
标称供电电压 (Vsup):5 V表面贴装:NO
技术:BIFET温度等级:COMMERCIAL
端子面层:Nickel/Palladium/Gold (Ni/Pd/Au)端子形式:THROUGH-HOLE
端子节距:2.54 mm端子位置:DUAL
处于峰值回流温度下的最长时间:NOT SPECIFIED标称均一增益带宽:1100 kHz
最小电压增益:5000宽带:NO
宽度:7.62 mmBase Number Matches:1

TL032ACP 数据手册

 浏览型号TL032ACP的Datasheet PDF文件第2页浏览型号TL032ACP的Datasheet PDF文件第3页浏览型号TL032ACP的Datasheet PDF文件第4页浏览型号TL032ACP的Datasheet PDF文件第5页浏览型号TL032ACP的Datasheet PDF文件第6页浏览型号TL032ACP的Datasheet PDF文件第7页 
TL03x, TL03xA, TL03xY  
ENHANCED-JFET LOW-POWER LOW-OFFSET  
OPERATIONAL AMPLIFIERS  
SLOS180B – FEBRUARY 1997 – REVISED FEBRUARY 1999  
Direct Upgrades for the TL06x Low-Power  
BiFETs  
Higher Slew Rate and Bandwidth Without  
Increased Power Consumption  
Low Power Consumption . . .  
6.5 mW/Channel Typ  
Available in TSSOP for Small Form-Factor  
Designs  
On-Chip Offset-Voltage Trimming for  
Improved DC Performance  
(1.5 mV, TL031A)  
description  
The TL03x series of JFET-input operational amplifiers offer improved dc and ac characteristics over the TL06x  
family of low-power BiFET operational amplifiers. On-chip zener trimming of offset voltage yields precision  
grades as low as 1.5 mV (TL031A) for greater accuracy in dc-coupled applications. Texas Instruments improved  
BiFET process and optimized designs also yield improved bandwidths and slew rates without increased power  
consumption. The TL03x devices are pin-compatible with the TL06x and can be used to upgrade existing  
circuits or for optimal performance in new designs.  
BiFET operational amplifiers offer the inherently higher input impedance of the JFET-input transistors without  
sacrificing the output drive associated with bipolar amplifiers. This higher input impedance makes the TL3x  
amplifiers better suited for interfacing with high-impedance sensors or very low-level ac signals. These devices  
also feature inherently better ac response than bipolar or CMOS devices having comparable power  
consumption.  
The TL03x family has been optimized for micropower operation, while improving on the performance of the  
TL06x series. Designers requiring significantly faster ac response should consider the Excalibur TLE206x  
family of low-power BiFET operational amplifiers.  
Because BiFET operational amplifiers are designed for use with dual power supplies, care must be taken to  
observe common-mode input-voltage limits and output swing when operating from a single supply. DC biasing  
of the input signal is required and loads should be terminated to a virtual-ground node at midsupply. Texas  
Instruments TLE2426 integrated virtual-ground generator is useful when operating BiFET amplifiers from single  
supplies.  
The TL03x devices are fully specified at ±15 V and ±5 V. For operation in low-voltage and/or single-supply  
systems, Texas Instruments LinCMOS families of operational amplifiers (TLC-prefix) are recommended. When  
moving from BiFET to CMOS amplifiers, particular attention should be paid to slew rate, bandwidth  
requirements, and output loading.  
The C-suffix devices are characterized for operation from 0°C to 70°C. The I-suffix devices are characterized  
for operation from –40°C to 85°C. The M-suffix devices are characterized for operation over the full military  
temperature range of –55°C to 125°C.  
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of  
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.  
Copyright 1999, Texas Instruments Incorporated  
PRODUCTION DATA information is current as of publication date.  
Products conform to specifications per the terms of Texas Instruments  
standard warranty. Production processing does not necessarily include  
testing of all parameters.  
1
POST OFFICE BOX 655303 DALLAS, TEXAS 75265  

TL032ACP 替代型号

型号 品牌 替代类型 描述 数据表
TL052ACPE4 TI

类似代替

ENHANCED-JFET LOW-OFFSET OPERATIONAL AMPLIFIERS
TL052ACP TI

类似代替

ENHANCED-JFET LOW-OFFSET OPERATIONAL AMPLIFIERS
TL051ACP TI

类似代替

ENHANCED-JFET LOW-OFFSET OPERATIONAL AMPLIFIERS

与TL032ACP相关器件

型号 品牌 获取价格 描述 数据表
TL032ACPE4 TI

获取价格

ENHANCED-JFET LOW-POWER LOW-OFFSET OPERATIONAL AMPLIFIERS
TL032AID TI

获取价格

ENHANCED-JFET LOW-POWER LOW-OFFSET OPERATIONAL AMPLIFIERS
TL032AID ROCHESTER

获取价格

DUAL OP-AMP, 4600uV OFFSET-MAX, 1MHz BAND WIDTH, PDSO8, GREEN, PLASTIC, MS-012AA, SOIC-8
TL032AIDE4 TI

获取价格

ENHANCED-JFET LOW-POWER LOW-OFFSET OPERATIONAL AMPLIFIERS
TL032AIDG4 TI

获取价格

ENHANCED-JFET LOW-POWER LOW-OFFSET OPERATIONAL AMPLIFIERS
TL032AIDR TI

获取价格

ENHANCED-JFET LOW-POWER LOW-OFFSET OPERATIONAL AMPLIFIERS
TL032AIDRE4 TI

获取价格

ENHANCED-JFET LOW-POWER LOW-OFFSET OPERATIONAL AMPLIFIERS
TL032AIDRG4 TI

获取价格

ENHANCED-JFET LOW-POWER LOW-OFFSET OPERATIONAL AMPLIFIERS
TL032AIJG TI

获取价格

DUAL OP-AMP, 2600uV OFFSET-MAX, 1.1MHz BAND WIDTH, CDIP8, 0.300 INCH, HERMETIC SEALED, CER
TL032AIP TI

获取价格

ENHANCED-JFET LOW-POWER LOW-OFFSET OPERATIONAL AMPLIFIERS