5秒后页面跳转
PCA9534APW PDF预览

PCA9534APW

更新时间: 2024-01-17 15:36:52
品牌 Logo 应用领域
德州仪器 - TI 并行IO端口微控制器和处理器外围集成电路光电二极管输出元件时钟
页数 文件大小 规格书
35页 644K
描述
REMOTE 8-BIT I2C AND SMBus LOW-POWER I/O EXPANDER WITH INTERRUPT OUTPUT AND CONFIGURATION REGISTERS

PCA9534APW 技术参数

是否无铅:不含铅是否Rohs认证:符合
生命周期:Active零件包装代码:QFN
包装说明:QFN-16针数:16
Reach Compliance Code:compliantECCN代码:EAR99
HTS代码:8542.39.00.01Factory Lead Time:1 week
风险等级:0.82Is Samacsys:N
最大时钟频率:0.4 MHzJESD-30 代码:S-PQCC-N16
JESD-609代码:e4长度:4 mm
湿度敏感等级:2位数:8
I/O 线路数量:8端口数量:1
端子数量:16最高工作温度:85 °C
最低工作温度:-40 °C封装主体材料:PLASTIC/EPOXY
封装代码:HVQCCN封装等效代码:LCC16,.16SQ,25
封装形状:SQUARE封装形式:CHIP CARRIER, HEAT SINK/SLUG, VERY THIN PROFILE
峰值回流温度(摄氏度):260电源:2.5/5 V
认证状态:Not Qualified座面最大高度:1 mm
子类别:Parallel IO Ports最大压摆率:0.175 mA
最大供电电压:5.5 V最小供电电压:2.3 V
标称供电电压:5 V表面贴装:YES
技术:CMOS温度等级:INDUSTRIAL
端子面层:Nickel/Palladium/Gold (Ni/Pd/Au)端子形式:NO LEAD
端子节距:0.65 mm端子位置:QUAD
处于峰值回流温度下的最长时间:NOT SPECIFIED宽度:4 mm
uPs/uCs/外围集成电路类型:PARALLEL IO PORT, GENERAL PURPOSEBase Number Matches:1

PCA9534APW 数据手册

 浏览型号PCA9534APW的Datasheet PDF文件第2页浏览型号PCA9534APW的Datasheet PDF文件第3页浏览型号PCA9534APW的Datasheet PDF文件第4页浏览型号PCA9534APW的Datasheet PDF文件第5页浏览型号PCA9534APW的Datasheet PDF文件第6页浏览型号PCA9534APW的Datasheet PDF文件第7页 
PCA9534A  
REMOTE 8-BIT I2C AND SMBus LOW-POWER I/O EXPANDER  
WITH INTERRUPT OUTPUT AND CONFIGURATION REGISTERS  
www.ti.com  
SCPS141BSEPTEMBER 2006REVISED MARCH 2007  
FEATURES  
Low Standby Current Consumption of  
1 µA Max  
Power-Up With All Channels Configured as  
Inputs  
I2C to Parallel Port Expander  
No Glitch on Power-Up  
Open-Drain Active-Low Interrupt Output  
Noise Filter on SCL/SDA Inputs  
Operating Power-Supply Voltage Range of  
2.3 V to 5.5 V  
Latched Outputs With High-Current Drive  
Maximum Capability for Directly Driving LEDs  
5-V Tolerant I/O Ports  
400-kHz Fast I2C Bus  
Latch-Up Performance Exceeds 100 mA Per  
JESD 78, Class II  
ESD Protection Exceeds JESD 22  
Three Hardware Address Pins Allow up to  
Eight Devices on the I2C/SMBus  
2000-V Human-Body Model (A114-A)  
200-V Machine Model (A115-A)  
Input/Output Configuration Register  
Polarity Inversion Register  
Internal Power-On Reset  
1000-V Charged-Device Model (C101)  
DB, DBQ, DGV, DW, OR PW PACKAGE  
(TOP VIEW)  
RGV PACKAGE  
(TOP VIEW)  
RGT PACKAGE  
(TOP VIEW)  
16  
15  
14  
13  
12  
11  
10  
9
A0  
A1  
1
2
3
4
5
6
7
8
VCC  
SDA  
SCL  
INT  
P7  
16 15 14 13  
16 15 14 13  
1
2
12  
A2  
P0  
P1  
SCL  
INT  
P7  
1
12  
SCL  
INT  
P7  
A2  
P0  
P1  
P2  
A2  
2
3
4
11  
10  
9
11  
P0  
3
4
10  
P1  
P6  
5
6
7
8
9
P2  
P6  
P2  
P6  
5
6
7
8
P3  
P5  
GND  
P4  
DESCRIPTION/ORDERING INFORMATION  
This 8-bit I/O expander for the two-line bidirectional bus (I2C) is designed for 2.3-V to 5.5-V VCC operation. It  
provides general-purpose remote I/O expansion for most microcontroller families via the I2C interface [serial  
clock (SCL), serial data (SDA)].  
The PCA9534A consists of one 8-bit configuration (input or output selection), input port, output port, and polarity  
inversion (active high or active low) register. At power on, the I/Os are configured as inputs. However, the  
system master can enable the I/Os as either inputs or outputs by writing to the I/O configuration bits. The data  
for each input or output is kept in the corresponding input or output register. The polarity of the input port register  
can be inverted with the polarity inversion register. All registers can be read by the system master.  
The system master can reset the PCA9534A in the event of a timeout or other improper operation by utilizing  
the power-on reset feature, which puts the registers in their default state and initializes the I2C/SMBus state  
machine.  
The PCA9534A open-drain interrupt (INT) output is activated when any input state differs from its corresponding  
input port register state and is used to indicate to the system master that an input state has changed.  
INT can be connected to the interrupt input of a microcontroller. By sending an interrupt signal on this line, the  
remote I/O can inform the microcontroller if there is incoming data on its ports without having to communicate via  
the I2C bus. Thus, the PCA9534A can remain a simple slave device.  
The device's outputs (latched) have high-current drive capability for directly driving LEDs. It has low current  
consumption.  
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of Texas  
Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.  
UNLESS OTHERWISE NOTED this document contains  
Copyright © 2006–2007, Texas Instruments Incorporated  
PRODUCTION DATA information current as of publication date.  
Products conform to specifications per the terms of Texas  
Instruments standard warranty. Production processing does not  
necessarily include testing of all parameters.  

与PCA9534APW相关器件

型号 品牌 描述 获取价格 数据表
PCA9534APWG4 TI REMOTE 8-BIT I2C AND SMBus LOW-POWER I/O EXPANDER WITH INTERRUPT OUTPUT AND CONFIGURATION

获取价格

PCA9534APWR TI REMOTE 8-BIT I2C AND SMBus LOW-POWER I/O EXPANDER WITH INTERRUPT OUTPUT AND CONFIGURATION

获取价格

PCA9534APWRG4 TI REMOTE 8-BIT I2C AND SMBus LOW-POWER I/O EXPANDER WITH INTERRUPT OUTPUT AND CONFIGURATION

获取价格

PCA9534ARGTR TI REMOTE 8-BIT I2C AND SMBus LOW-POWER I/O EXPANDER WITH INTERRUPT OUTPUT AND CONFIGURATION

获取价格

PCA9534ARGTRG4 TI REMOTE 8-BIT I2C AND SMBus LOW-POWER I/O EXPANDER WITH INTERRUPT OUTPUT AND CONFIGURATION

获取价格

PCA9534ARGTT TI IC 8 I/O, PIA-GENERAL PURPOSE, PQCC16, PLASTIC, QFP-16, Parallel IO Port

获取价格