5秒后页面跳转
TDA3683J PDF预览

TDA3683J

更新时间: 2024-09-08 21:16:55
品牌 Logo 应用领域
飞利浦 - PHILIPS /
页数 文件大小 规格书
30页 144K
描述
Power Management Circuit, CMOS, PZIP23,

TDA3683J 技术参数

生命周期:Transferred包装说明:ZIP, ZIP23,.2,.17
Reach Compliance Code:unknown风险等级:5.68
JESD-30 代码:R-PZIP-T23端子数量:23
最高工作温度:85 °C最低工作温度:-40 °C
封装主体材料:PLASTIC/EPOXY封装代码:ZIP
封装等效代码:ZIP23,.2,.17封装形状:RECTANGULAR
封装形式:IN-LINE电源:14.4 V
认证状态:Not Qualified子类别:Power Management Circuits
最大供电电流 (Isup):0.45 mA标称供电电压 (Vsup):14.4 V
表面贴装:NO技术:CMOS
温度等级:INDUSTRIAL端子形式:THROUGH-HOLE
端子节距:1.27 mm端子位置:ZIG-ZAG
Base Number Matches:1

TDA3683J 数据手册

 浏览型号TDA3683J的Datasheet PDF文件第2页浏览型号TDA3683J的Datasheet PDF文件第3页浏览型号TDA3683J的Datasheet PDF文件第4页浏览型号TDA3683J的Datasheet PDF文件第5页浏览型号TDA3683J的Datasheet PDF文件第6页浏览型号TDA3683J的Datasheet PDF文件第7页 
TDA3683J  
Multiple voltage regulator with switch and ignition buffer  
Rev. 01 — 13 December 2004  
Preliminary data sheet  
1. General description  
The TDA3683J is a multiple output voltage regulator with a power switch and an  
ignition buffer. Several protections and diagnostic options are incorporated in this  
design.  
The TDA3683J is primarily developed to cover the complete power supply  
requirements in car radio applications  
The standby regulators (regulators 1, 2 and 3) are especially designed to supply  
digital circuitry that has to be permanently connected e.g. CAN bus, DPS core and the  
microcontroller. In combination with the reset delay capacitor (RDC1 or RDC2/3) and  
the reset function (RST1 or RST2/3), a proper start-up sequence for a microcontroller  
is guaranteed. The storage capacitor (STC) makes the standby regulator outputs  
insensitive for short battery drops (e.g. during engine start-up).  
The switched regulators (regulators 4, 5, 6 and 7) are intended to be used as supply  
for the tuner, logic, sound processor and CD / tape control  
The power switch (PSW) can be used for switching the electrically powered antenna,  
display unit and CD / tape drives  
The ignition buffer (IGN) is intended to produce a clean logic output signal when a  
polluted ignition key signal is used as input.  
2. Features  
Three enable pin controlled standby regulators:  
REG1: 5 V / 600 mA controlled by the EN1 input  
REG2: 3.3 V / 200 mA controlled by the EN2/3 input  
REG3: 1.9 V / 150 mA controlled by the EN2/3 input  
Four mode pin controlled switched regulators:  
REG4: 8.5 V / 350 mA  
REG5: 5 V / 1.8 A  
REG6: 3.3 V / 1.2 A  
REG7: 2.4 V to 10 V / 2 A adjustable using external resistor divider  
One mode pin controlled power switch; 2.2 A continuous and 3 A surge, with delayed  
lower current limit so as to be less sensitive to inrush currents  
One independent ignition buffer (inverted output, open-collector) with good input  
protection against high transients  
A storage capacitor is included to provide back-up supply for the standby regulators in  
the event of loss of battery supply  
A hold output (3-state) which can be used to communicate to a microcontroller in the  
event of an internal or external fault condition, such as:  
 
 

与TDA3683J相关器件

型号 品牌 获取价格 描述 数据表
TDA3683J/N2S,112 NXP

获取价格

TDA3683 - Multiple voltage regulator with switch and ignition buffer ZIP 23-Pin
TDA3683SD NXP

获取价格

SEVEN OUTPUT, FIXED/ADJUSTABLE POSITIVE REGULATOR, PZFM23, PLASTIC, SOT889-1, DIL BENT SIL
TDA3717 ETC

获取价格

STEPPER MOTOR DRIVE CIRCUIT
TDA3717-DPB DYNEX

获取价格

Motion Control Electronic, BIPolar, PDIP16
TDA3724 NXP

获取价格

SECAM IDENTIFICATION CIRCUIT
TDA3740 NXP

获取价格

VIDEO PROCESSOR AND FREQUENCY MODULATOR FOR VIDEO RECORDERS
TDA3755 NXP

获取价格

PAL/NTSC/SECAM synchronization processor for video recorders
TDA38 ADAM-TECH

获取价格

Barrier Strip Terminal Block, 10A, 1 Deck(s)
TDA3800 ETC

获取价格

STEREO/DUAL TV SOUND PROCESSING CIRCUITS
TDA3800G ETC

获取价格

STEREO/DUAL TV SOUND PROCESSING CIRCUITS