TC9591XBG
CMOS Digital Integrated Circuit Silicon Monolithic
TC9591XBG
Automotive Peripheral Devices
TC9591XBG
Overview
The MIPI® CSI-2SM to Parallel port and Parallel port to CSI-2
(TC9591XBG) is a bridge device that has both functions to convert
MIPI data transfers from devices such as a camera to an application
processor over a Parallel port interface and to convert parallel data
transfers to an application over a MIPI CSI-2 interface. All internal
registers can be accessed through I2C or SPI (in CSI out case only).
Weight: 68 mg (Typ.)
P-VFBGA80-0707-0.65-001
Features
● CSI-2 TX/RX interface
● GPIO signals
MIPI CSI-2 compliant (Version 1.01 Revision
3 GPIO signals
0.04 – 2 April 2009)
- Three GPIO signals can be configured as
control signals (MCLK, CXRST, XShutdown) for
CSI-2 RX device.
- Or one GPIO signal can be configured as INT
signal for Parallel interface.
Configurable to TX or RX controller
Supports up to 1Gbps per data lane
Supports up to 4 data lanes
Supports video data formats
- RX: RAW8/10/12/14, YUV422 (CCIR/ITU 8/10-
bit), RGB888/666/565 and User-Defined 8-bit
- TX: YUV422 (CCIR/ITU 8/10-bit), YUV444,
RGB888/666/565 and RAW8/10/12/14
● System
Clock and power management support to
achieve low power states.
● Power supply inputs
Core and MIPI D-PHY: 1.2 V
I/O: 1.8 V or 3.3 V
● Parallel Port Interface
Supports data formats
- 24-bit bus – un-packed format (Both Input and
Output mode)
RGB888/666/565, RAW8/10/12/14 and
YUV422 8-bit (on 8/16-bit data bus) and 10-bit
data formats.
YUV444 (Parallel Input mode only)
- YUV422 8-bit – ITU BT.656 and ITU BT.601
(Parallel input mode only)
● Operation temperature
Ta = -40 °C to 105 °C
● AEC-Q100 qualified with the following definition
Grade 2 : -40 °C to 105 °C ambient operating
temperature range
Up to 100 MHz PCLK frequency for Output
mode, and 166 MHz for Input mode.
● I2C Slave Interface (CS = L)
Support for normal (100 kHz), fast mode (400
kHz) and special mode (1 MHz)
Configure all TC9591XBG internal registers
● SPI Slave Interface (Only applicable in CSIOut
configuration, MSEL = H, and CS = H)
SPI interface support for up to 25 MHz
operation.
Configure all TC9591XBG internal registers
© 2014-2020
Toshiba Electronic Devices & Storage Corporation
1 / 17
2020-06-05
Rev.1.0