5秒后页面跳转
TB6613FTG PDF预览

TB6613FTG

更新时间: 2024-11-23 12:33:23
品牌 Logo 应用领域
东芝 - TOSHIBA 运动控制电子器件信号电路电动机控制
页数 文件大小 规格书
30页 432K
描述
TOSHIBA BiCD Integrated Circuit Silicon Monolithic

TB6613FTG 技术参数

是否Rohs认证: 符合生命周期:Obsolete
零件包装代码:QFN包装说明:0.4 MM PITCH, PLASTIC, VQON-44
针数:44Reach Compliance Code:unknown
ECCN代码:EAR99HTS代码:8542.39.00.01
风险等级:5.84Is Samacsys:N
模拟集成电路 - 其他类型:STEPPER MOTOR CONTROLLERJESD-30 代码:S-PQCC-N44
长度:5.3 mm功能数量:1
端子数量:44最高工作温度:85 °C
最低工作温度:-20 °C最大输出电流:0.8 A
封装主体材料:PLASTIC/EPOXY封装代码:HVQCCN
封装等效代码:LCC44,.2SQ,16封装形状:SQUARE
封装形式:CHIP CARRIER, HEAT SINK/SLUG, VERY THIN PROFILE电源:3.3 V
认证状态:Not Qualified座面最大高度:0.6 mm
子类别:Motion Control Electronics最大供电电流 (Isup):4 mA
最大供电电压 (Vsup):5.5 V最小供电电压 (Vsup):2.5 V
标称供电电压 (Vsup):5 V表面贴装:YES
技术:BCDMOS温度等级:OTHER
端子形式:NO LEAD端子节距:0.4 mm
端子位置:QUAD宽度:5.3 mm
Base Number Matches:1

TB6613FTG 数据手册

 浏览型号TB6613FTG的Datasheet PDF文件第2页浏览型号TB6613FTG的Datasheet PDF文件第3页浏览型号TB6613FTG的Datasheet PDF文件第4页浏览型号TB6613FTG的Datasheet PDF文件第5页浏览型号TB6613FTG的Datasheet PDF文件第6页浏览型号TB6613FTG的Datasheet PDF文件第7页 
TB6613FTG  
TOSHIBA BiCD Integrated Circuit Silicon Monolithic  
TB6613FTG  
DC and Stepping Motor Driver  
The TB6613FTG is a DC motor driver IC using LDMOS output  
transistors with low ON-resistance.  
The TB6613FTG incorporates five PWM constant-current  
H-bridge drivers, of which four drivers can be used for micro  
stepping motor drives of up to two stepping motors.  
The TB6613FTG is best suited to control various lens actuators  
in digital still cameras.  
The three-wire serial interface provides control over the drivers,  
thus reducing the number of lines required for interfacing with  
the control IC.  
Weight: 0.05 g (typ.)  
Features  
Motor power supply voltage: VM 6 V (max)  
Control power supply voltage: V = 3 V to 5.5 V  
CC  
Output current: I  
0.8 A (max)  
OUT  
Complementally P- and N-channel LDMOS output transistors  
Output ON-resistance: R (upper and lower sum) = 1.5 (@VM = V  
= 5 V typ.)  
CC  
ON  
Channels A, B, C and D  
Four H-bridge drivers capable of PWM constant-current control  
Supports up to two two-phase bipolar stepping motors (STMs) or up to four actuators.  
Each channel is individually configurable for either H-Bridge mode or STM μStep mode via the serial  
interface.  
In STM μStep mode, the micro stepping resolution is selectable from 6 bits (256 steps per full cycle) or 1 bit (8  
steps per full cycle).  
Channel E  
One PWM constant-current driver  
The constant-current reference voltage (Vref) is programmable via the internal 6-bit DAC.  
Other Features  
Each channel has a DAC for setting constant-current values (Channels A to D = 2 bits in H-Bridge mode and  
2 bits × 6 bits in μStep mode; Channel E = 6 bits)  
Dedicated standby (power-save) pin  
Thermal shutdown (TSD)  
Undervoltage lockout (UVLO): Resets and disables the internal circuitry when V  
falls below 2.2 V (typ.).  
CC  
Small VQON44 package (0.4-mm lead pitch)  
Note: This product has a MOS structure and is sensitive to electrostatic discharge. When handling this product,  
ensure that the environment is protected against electrostatic discharge by using an earth strap, a  
conductive mat and an ionizer. Ensure also that the ambient temperature and relative humidity are  
maintained at reasonable levels.  
1
2012-01-30  

与TB6613FTG相关器件

型号 品牌 获取价格 描述 数据表
TB6613FTG(O,8,EL) TOSHIBA

获取价格

UNIPOLAR MOTOR DRIVER IC PB-FREE
TB6614FNG TOSHIBA

获取价格

IC BRUSHLESS DC MOTOR CONTROLLER, 4.5 A, PDSO16, 0.225 INCH, 0.65 MM PITCH, PLASTIC, SSOP-
TB6614FNG,C,EL TOSHIBA

获取价格

BRUSHLESS DC MOTOR CONTROLLER
TB6615PG TOSHIBA

获取价格

Stepping motor driver IC
TB6615PG(O,8) TOSHIBA

获取价格

STEPPING MOTOR DRIVER IC PB-FREE
TB6615PG,8 TOSHIBA

获取价格

TB6615PG,8
TB6617FNG TOSHIBA

获取价格

IC BRUSHLESS DC MOTOR CONTROLLER, 2 A, PDSO16, 0.225 INCH, 0.65 MM PITCH, PLASTIC, SSOP-16
TB6631FNG TOSHIBA

获取价格

Controller
TB6633AFNG TOSHIBA

获取价格

IC BRUSHLESS DC MOTOR CONTROLLER, Motion Control Electronics
TB6633FNG TOSHIBA

获取价格

IC BRUSHLESS DC MOTOR CONTROLLER, Motion Control Electronics