TB6560HQ/FG
TOSHIBA BiCD Integrated Circuit Silicon Monolithic
Preliminary
TB6560HQ,TB6560FG
PWM Chopper-Type bipolar
Stepping Motor Driver IC
TB6560HQ
The TB6560HQ/FG is a PWM chopper-type sinusoidal micro-step
bipolar stepping motor driver IC.
It supports both 2-phase/1-2-phase/W1-2-phase/2W1-2-phase
excitation mode and forward/reverse mode and is capable of
low-vibration, high-performance drive of 2-phase bipolar type
stepping motors using only a clock signal.
Features
TB6560FG
•
Single-chip bipolar sinusoidal micro-step stepping motor
driver
•
Uses high withstand voltage BiCD process:
Ron (upper lower) = 0.6 Ω (typ.)
•
•
•
•
Forward and reverse rotation control available
Selectable phase drive (2, 1-2, W1-2, and 2W1-2)
High output withstand voltage: V
= 40 V
CEO
High output current: I
= HQ: 3.5 A (peak)
OUT
FG: 2.5 A (peak)
Weight:
•
•
•
•
•
Packages: HZIP25-P-1.27/HQFP64-P-1010-0.50
HZIP25-P-1.27: 9.86 g (typ.)
HQFP64-P-1010-0.50: 0.26 g (typ.)
Built-in input pull-down resistor: 100 kΩ (typ.)
Output monitor pin equipped: MO current (I
Equipped with reset and enable pins
Built-in overheat protection circuit
(max) = 1 mA)
MO
The TB6560HQ/FG is a Pb-free product.
The following conditions apply to solderability:
*Solderability
1. Use of Sn-63Pb solder bath
*solder bath temperature = 230°C
*dipping time = 5 seconds
*number of times = once
*use of R-type flux
2. Use of Sn-3.0Ag-0.5Cu solder bath
*solder bath temperature = 245°C
*dipping time = 5 seconds
*the number of times = once
*use of R-type flux
*: Since this product has a MOS structure, it is sensitive to electrostatic discharge. These ICs are highly sensitive to
electrostatic discharge. When handling them, please be careful of electrostatic discharge, temperature and
humidity conditions.
1
2006-05-31