5秒后页面跳转
SY88903VKC PDF预览

SY88903VKC

更新时间: 2024-11-09 03:00:15
品牌 Logo 应用领域
麦瑞 - MICREL 电信集成电路放大器光电二极管异步传输模式ATM
页数 文件大小 规格书
6页 465K
描述
5V/3.3V 1.25Gbps HIGH-SPEED LIMITING POST AMPLIFIER

SY88903VKC 数据手册

 浏览型号SY88903VKC的Datasheet PDF文件第2页浏览型号SY88903VKC的Datasheet PDF文件第3页浏览型号SY88903VKC的Datasheet PDF文件第4页浏览型号SY88903VKC的Datasheet PDF文件第5页浏览型号SY88903VKC的Datasheet PDF文件第6页 
SY88903V  
5V/3.3V 1.25Gbps HIGH-SPEED  
LIMITING POST AMPLIFIER  
FEATURES  
DESCRIPTION  
3.3V and 5V power supply option  
Up to 1.25Gbps operation  
Low noise  
The SY88903V limiting post amplifier with its high gain  
and wide bandwidth is ideal for use as a post amplifier in  
fiber optic receivers with data rates up to 1.25Gbps. Signals  
as small as 5mV can be amplified to drive devices with  
pp  
Chatter-free LOS generation  
Open collector TTL LOS output  
TTL /EN Input  
PECL inputs. The SY88903V generates a chatter-free, Loss-  
-of-Signal (LOS), open-collector TTL output.  
The SY88903V is an integrated limiting amplifier intended  
for high-frequency fiber optic applications. The circuit  
connects to typical transimpedance amplifiers found within  
a fiber optics link. The linear signal output from a  
transimpedance amplifier can contain significant amounts  
of noise, and may vary in amplitude over time. The  
SY88903V limiting amplifier quantizes the signal and outputs  
a voltage-limited waveform.  
Differential PECL inputs for data  
Single power supply  
Designed for use with laser diode driver and  
controller  
Available in a tiny 10-pin (3mm × 3mm) MSOP  
The /EN pin allows the user to disable the output signal  
without removing the input signal.  
The SY88903V incorporates a programmable level detect  
function to identify when the input signal has been lost.  
This information can be fed back to the /EN input of the  
device to maintain stability under loss of signal condition.  
The sensitivity of the level detection can be adjusted using  
APPLICATIONS  
1.25Gbps Gigabit Ethernet  
531Mbps and 1062Mbps Fibre Channel  
622Mbps SONET  
LOS . The LOS  
resistor divider between V and V  
voltage can be set by connecting a  
as shown in Figure  
REF  
LVL  
LVL  
Gigabit Interface Converter  
CC  
3. “Typical Characteristics” show the relationship between  
input level sensitivity and the voltage set on LOS  
.
LVL  
The LOS output is a TTL open-collector output that  
requires a pull-up resistor for proper operation, Figure 1.  
VCC  
BLOCK DIAGRAM  
SY88903V  
2.5k  
LOS  
D
D
IN  
IN  
D
OUT  
OUT  
Limiting  
Amplifer  
ECL  
Buffer  
Figure 1. LOS Output with Desired Rise Time  
D
All support documentation can be found on Micrel’s web  
site at www.micrel.com.  
V
REF  
CC  
Enable  
EN  
V
Level  
Detect  
GND  
LOS  
LOSLVL  
Rev.: E  
Amendment: /0  
M9999-091406  
hbwhelp@micrel.com or (408) 955-1690  
1
Issue Date: September2006  

与SY88903VKC相关器件

型号 品牌 获取价格 描述 数据表
SY88903VKCTR MICROCHIP

获取价格

ATM/SONET/SDH SUPPORT CIRCUIT, PDSO10
SY88903VKCTR MICREL

获取价格

5V/3.3V 1.25Gbps HIGH-SPEED LIMITING POST AMPLIFIER
SY88903VKG MICREL

获取价格

5V/3.3V 1.25Gbps HIGH-SPEED LIMITING POST AMPLIFIER
SY88903VKGTR MICREL

获取价格

5V/3.3V 1.25Gbps HIGH-SPEED LIMITING POST AMPLIFIER
SY88903VKGTR MICROCHIP

获取价格

ATM/SONET/SDH SUPPORT CIRCUIT, PDSO10
SY88904 MICREL

获取价格

FIBER OPTIC MODULE CONTROLLER WITH APC
SY88904KC MICREL

获取价格

FIBER OPTIC MODULE CONTROLLER WITH APC
SY88904KC MICROCHIP

获取价格

SPECIALTY TELECOM CIRCUIT, PDSO16
SY88904KCTR MICREL

获取价格

FIBER OPTIC MODULE CONTROLLER WITH APC
SY88904KCTR MICROCHIP

获取价格

SPECIALTY TELECOM CIRCUIT, PDSO16, MSOP-16