a
Balanced Line Driver
SSM2142
FUNCTIO NAL BLO CK D IAGRAM
FEATURES
Transform er-Like Balanced Output
Drives 10 V RMS Into a 600 ⍀ Load
Stable When Driving Large Capacitive Loads and Long
Cables
VIN
50Ω
Low Distortion
+OUT FORCE
0.006% typ 20 Hz–20 kHz, 10 V RMS into 600 ⍀
High Slew Rate
15 V/ s typ
+OUT SENSE
10kΩ
Low Gain Error
– OUT SENSE
(Differential or Single-Ended); 0.7% typ
Outputs Short-Circuit Protected
Available In Space-Saving 8-Pin Mini-DIP Package
Low Cost
50Ω
– OUT FORCE
APPLICATIONS
Audio Mix Consoles
ALL RESISTORS 30kΩ
Distribution Am plifiers
Graphic and Param etric Equalizers
Dynam ic Range Processors
Digital Effects Processors
Telecom m unications System s
Industrial Instrum entation
Hi-Fi Equipm ent
10kΩ
UNLESS OTHERWISE
INDICATED
GND
GENERAL D ESCRIP TIO N
Based on a cross-coupled, electronically balanced topology, the
SSM2142 mimics the performance of fully balanced
transformer-based solutions for line driving. However, the
SSM2142 maintains lower distortion and occupies much less
board space than transformers while achieving comparable
common-mode rejection performance with reduced parts count.
T he SSM2142 is an integrated differential-output buffer
amplifier that converts a single-ended input signal to a balanced
output signal pair with high output drive. By utilizing low noise
thermally matched thin film resistors and high slew rate
amplifiers, the SSM2142 helps maintain the sonic quality of
audio systems by eliminating power line hum, RF interference,
voltage drops, and other externally generated noise commonly
encountered with long audio cable runs. Excellent rejection of
common-mode noise and offset errors is achieved by laser
trimming of the onboard resistors, assuring high gain accuracy.
T he carefully designed output stage of the SSM2142 is capable
of driving difficult loads, yielding low distortion performance
despite extremely long cables or loads as low as 600 Ω, and is
stable over a wide range of operating conditions.
T he SSM2142 in tandem with the SSM2141 differential
receiver establishes a complete, reliable solution for driving and
receiving audio signals over long cables. T he SSM2141 features
an Input Common-Mode Rejection Ratio of 100 dB at 60 Hz.
Specifications demonstrating the performance of this typical
system are included in the data sheet.
REV. C
Inform ation furnished by Analog Devices is believed to be accurate and
reliable. However, no responsibility is assum ed by Analog Devices for its
use, nor for any infringem ents of patents or other rights of third parties
which m ay result from its use. No license is granted by im plication or
otherwise under any patent or patent rights of Analog Devices.
One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A.
www.analog.com
Tel: 781.329.4700
Fax: 781.461.3113 ©1991–2011 Analog Devices, Inc. All rights reserved.