5秒后页面跳转
SN75LPE185DW PDF预览

SN75LPE185DW

更新时间: 2024-11-18 22:53:31
品牌 Logo 应用领域
德州仪器 - TI 线路驱动器或接收器驱动程序和接口接口集成电路光电二极管
页数 文件大小 规格书
13页 184K
描述
LOW-POWER MULTIPLE RS-232 DRIVERS/RECEIVERS WITH ENABLE

SN75LPE185DW 技术参数

是否Rohs认证: 符合生命周期:Obsolete
零件包装代码:SOIC包装说明:SOP, SOP24,.4
针数:24Reach Compliance Code:unknown
ECCN代码:EAR99HTS代码:8542.39.00.01
Factory Lead Time:1 week风险等级:8.04
Is Samacsys:N差分输出:NO
驱动器位数:3高电平输入电流最大值:0.000001 A
输入特性:SCHMITT TRIGGER接口集成电路类型:LINE TRANSCEIVER
接口标准:EIA-232-F; TIA-232-F; V.28JESD-30 代码:R-PDSO-G24
长度:15.4 mm标称负供电电压:-12 V
功能数量:3端子数量:24
最高工作温度:70 °C最低工作温度:
最小输出摆幅:10 V最大输出低电流:0.002 A
封装主体材料:PLASTIC/EPOXY封装代码:SOP
封装等效代码:SOP24,.4封装形状:RECTANGULAR
封装形式:SMALL OUTLINE峰值回流温度(摄氏度):NOT SPECIFIED
电源:5,+-12 V认证状态:Not Qualified
最大接收延迟:900 ns接收器位数:5
座面最大高度:2.65 mm子类别:Line Driver or Receivers
最大供电电压:5.25 V最小供电电压:4.75 V
标称供电电压:5 V电源电压1-最大:15 V
电源电压1-分钟:9 V电源电压1-Nom:12 V
表面贴装:YES技术:BIPOLAR
温度等级:COMMERCIAL端子形式:GULL WING
端子节距:1.27 mm端子位置:DUAL
处于峰值回流温度下的最长时间:NOT SPECIFIED最大传输延迟:1600 ns
宽度:7.5 mmBase Number Matches:1

SN75LPE185DW 数据手册

 浏览型号SN75LPE185DW的Datasheet PDF文件第2页浏览型号SN75LPE185DW的Datasheet PDF文件第3页浏览型号SN75LPE185DW的Datasheet PDF文件第4页浏览型号SN75LPE185DW的Datasheet PDF文件第5页浏览型号SN75LPE185DW的Datasheet PDF文件第6页浏览型号SN75LPE185DW的Datasheet PDF文件第7页 
SN75LPE185  
LOW-POWER MULTIPLE RS-232 DRIVERS/RECEIVERS  
WITH ENABLE  
SLLS256D – DECEMBER 1996 – REVISED OCTOBER 1998  
DB, DW, NT, OR PW PACKAGE  
Single-Chip RS-232 Interface for IBM PC  
Compatible Serial Port  
(TOP VIEW)  
Designed to Transmit and Receive 4-µs Pulses  
(Equivalent to 256 kbit/s)  
V
V
CC  
1
24  
23  
22  
21  
20  
19  
18  
17  
16  
15  
14  
13  
DD  
RA1  
RA2  
RA3  
DY1  
DY2  
RA4  
DY3  
RA5  
RY1  
RY2  
RY3  
DA1  
DA2  
RY4  
DA3  
RY5  
GND  
NC  
2
Standby Power Is Less Than 750 µW Maximum  
3
Wide Supply-Voltage Range . . . 4.75 V to 15 V  
4
5
Driver Output Slew Rates Are Internally  
Controlled to 30-V/µs Maximum  
6
7
RS-232 Bus-Pin ESD Protection Exceeds:  
– 15 kV, Human-Body Model  
– 8-kV IEC1000-4-2, Contact  
8
9
V
10  
11  
SS  
– 15-kV IEC1000-4-2, Air Gap  
EN  
Receiver Input Hysteresis . . . 1000 mV Typical  
MODE 12  
NC  
Three Drivers and Five Receivers Meet or  
Exceed the Requirements of TIA/EIA-232-F and  
ITU v.28 Standards  
NC – No internal connection  
Complements the SN75LP196  
One Receiver Remains Active During WAKE-UP  
Mode (100 µA Maximum)  
Matches the Flow-Through Pinout of the  
Industry-Standard SN75185, SN75C185, and  
SN75LP185, With Additional Control Pins  
Package Options Include Plastic Shrink  
Small-Outline (DB), Small-Outline (DW), Thin  
Shrink Small-Outline (PW), and Standard  
Plastic (NT) DIPs  
description  
The SN75LPE185 is a low-power bipolar device containing three drivers and five receivers, with 15-kV ESD  
protection on the bus pins, with respect to each other. Bus pins are defined as those pins that tie directly to the  
serial-port connector, including GND. The pinout matches the flow-through design of the industry-standard  
SN75185, SN75C185, and SN75LP185, with the addition of four pins for control signals. The flow-through  
pinout of the device allows easy interconnection of the UART and serial-port connector of the IBM PC  
compatibles. The SN75LPE185 provides a rugged, low-cost solution for this function with the combination of  
bipolar processing and 15-kV ESD protection.  
The SN75LPE185 has an internal slew-rate control to provide a maximum rate of change in the output signal  
of 30 V/µs. The driver output swing is clamped at ±6 V to enable the higher data rates associated with this device  
and reduce EMI emissions. Although the driver outputs are clamped, the outputs can handle voltages up to  
±15 V without damage.  
The device has flexible control options for power management when the serial port is inactive. A common  
disable for all of the drivers and receivers is provided with the active-low enable (EN) input. The mode control  
(MODE) input selects between the STANDBY and WAKE-UP modes. With a low-level input on the MODE pin  
and a high-level input on the EN pin, one receiver remains active while the remaining drivers and receivers are  
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of  
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.  
IBM and PC are trademarks of International Business Machines Corporation.  
Copyright 1998, Texas Instruments Incorporated  
PRODUCTION DATA information is current as of publication date.  
Products conform to specifications per the terms of Texas Instruments  
standard warranty. Production processing does not necessarily include  
testing of all parameters.  
1
POST OFFICE BOX 655303 DALLAS, TEXAS 75265  

与SN75LPE185DW相关器件

型号 品牌 获取价格 描述 数据表
SN75LPE185DWE4 TI

获取价格

LOW-POWER MULTIPLE RS-232 DRIVERS/RECEIVERS WITH ENABLE
SN75LPE185DWR TI

获取价格

LOW-POWER MULTIPLE RS-232 DRIVERS/RECEIVERS WITH ENABLE
SN75LPE185DWRE4 TI

获取价格

LOW-POWER MULTIPLE RS-232 DRIVERS/RECEIVERS WITH ENABLE
SN75LPE185NT TI

获取价格

LOW-POWER MULTIPLE RS-232 DRIVERS/RECEIVERS WITH ENABLE
SN75LPE185NTE4 TI

获取价格

LOW-POWER MULTIPLE RS-232 DRIVERS/RECEIVERS WITH ENABLE
SN75LPE185PW TI

获取价格

LOW-POWER MULTIPLE RS-232 DRIVERS/RECEIVERS WITH ENABLE
SN75LPE185PWR TI

获取价格

LOW-POWER MULTIPLE RS-232 DRIVERS/RECEIVERS WITH ENABLE
SN75LPE185PWRE4 TI

获取价格

LOW-POWER MULTIPLE RS-232 DRIVERS/RECEIVERS WITH ENABLE
SN75LPE185PWRG4 TI

获取价格

TRIPLE LINE TRANSCEIVER, PDSO24, GREEN, PLASTIC, TSSOP-24
SN75LV4735 TI

获取价格

3.3-V MULTICHANNEL RS-232 LINE DRIVER/RECEIVER