5秒后页面跳转
SN75LP1185DW PDF预览

SN75LP1185DW

更新时间: 2024-11-22 22:53:31
品牌 Logo 应用领域
德州仪器 - TI 线路驱动器或接收器驱动程序和接口接口集成电路光电二极管
页数 文件大小 规格书
8页 119K
描述
LOW-POWER MULTIPLE RS-232 DRIVERS AND RECEIVERS

SN75LP1185DW 技术参数

是否无铅: 不含铅是否Rohs认证: 符合
生命周期:Active零件包装代码:SOIC
包装说明:SOIC-20针数:20
Reach Compliance Code:compliantECCN代码:EAR99
HTS代码:8542.39.00.01Factory Lead Time:1 week
风险等级:5.18Samacsys Confidence:
Samacsys Status:ReleasedSamacsys PartID:607109
Samacsys Pin Count:20Samacsys Part Category:Integrated Circuit
Samacsys Package Category:OtherSamacsys Footprint Name:SOIC127P1032X265-20N
Samacsys Released Date:2017-01-12 12:59:53Is Samacsys:N
其他特性:ALSO REQUIRES -9 TO -15 SUPPLY差分输出:NO
驱动器位数:3高电平输入电流最大值:0.0000083 A
输入特性:SCHMITT TRIGGER接口集成电路类型:LINE TRANSCEIVER
接口标准:EIA-232-F; TIA-232-F; V.28JESD-30 代码:R-PDSO-G20
JESD-609代码:e4长度:12.8 mm
湿度敏感等级:1标称负供电电压:-12 V
功能数量:3端子数量:20
最高工作温度:70 °C最低工作温度:
最小输出摆幅:10 V最大输出低电流:0.002 A
封装主体材料:PLASTIC/EPOXY封装代码:SOP
封装等效代码:SOP20,.4封装形状:RECTANGULAR
封装形式:SMALL OUTLINE峰值回流温度(摄氏度):260
电源:5,+-12 V认证状态:Not Qualified
最大接收延迟:900 ns接收器位数:5
座面最大高度:2.65 mm子类别:Line Driver or Receivers
最大压摆率:1 mA最大供电电压:5.25 V
最小供电电压:4.75 V标称供电电压:5 V
电源电压1-最大:15 V电源电压1-分钟:9 V
电源电压1-Nom:12 V表面贴装:YES
技术:BIPOLAR温度等级:COMMERCIAL
端子面层:Nickel/Palladium/Gold (Ni/Pd/Au)端子形式:GULL WING
端子节距:1.27 mm端子位置:DUAL
处于峰值回流温度下的最长时间:NOT SPECIFIED最大传输延迟:1600 ns
宽度:7.5 mmBase Number Matches:1

SN75LP1185DW 数据手册

 浏览型号SN75LP1185DW的Datasheet PDF文件第2页浏览型号SN75LP1185DW的Datasheet PDF文件第3页浏览型号SN75LP1185DW的Datasheet PDF文件第4页浏览型号SN75LP1185DW的Datasheet PDF文件第5页浏览型号SN75LP1185DW的Datasheet PDF文件第6页浏览型号SN75LP1185DW的Datasheet PDF文件第7页 
SN75LP1185  
LOW-POWER MULTIPLE RS-232 DRIVERS AND RECEIVERS  
SLLS335 – JANUARY 1999  
DB, DW, N, OR PW PACKAGE  
Single-Chip TIA/EIA-232-F Interface for  
IBM PC/AT Serial Port  
(TOP VIEW)  
Designed to Transmit and Receive 4-µs  
Pulses (Equivalent to 256 kbit/s)  
V
V
CC  
1
2
3
4
5
6
7
8
9
10  
20  
19  
18  
17  
16  
15  
14  
13  
12  
11  
DD  
RA1  
RA2  
RA3  
DY1  
DY2  
RA4  
DY3  
RA5  
RY1  
RY2  
RY3  
DA1  
DA2  
RY4  
DA3  
RY5  
GND  
Less Than 21-mW Power Consumption  
Wide Supply-Voltage Range, 4.75 V to 15 V  
Driver Output Slew Rates Are Internally  
Controlled to 30 V/µs Max  
Receiver Input Hysteresis, 1000 mV Typ  
TIA/EIA-232-F Bus-Pin ESD Protection  
Exceeds:  
– 15-kV, Human-Body Model  
– IEC1000-4-2 Level-4 Compliant  
V
SS  
Three Drivers and Five Receivers Meet or  
Exceed the Requirements of TIA/EIA-232-F  
and ITU V.28  
Complements the SN75LP196  
Designed to Replace the Industry-Standard  
SN75185 and SN75C185 With the Same  
Flow-Through Pinout  
Package Options Include Plastic  
Small-Outline (DW), Shrink Small-Outline  
(DB), Thin Shrink Small-Outline (PW), and  
Dual-In-Line (N) Packages  
description  
The SN75LP1185 is a low-power bipolar device containing three drivers and five receivers with 15 kV of ESD  
protection on the bus pins with respect to each other. Bus pins are defined as those pins that tie directly to the  
serial-port connector, including GND. The pinout matches the flow-through design of the industry-standard  
SN75185 and SN75C185. The flow-through pinout of the SN75LP1185 allows easy interconnection of the  
UART and serial-port connector of the IBM PC/AT and compatibles. The SN75LP1185 provides a rugged,  
low-cost solution for this function with the combination of the bipolar processing and 15 kV of ESD protection.  
The SN75LP1185 has internal slew-rate control to provide a maximum rate of change in the output signal of  
30 V/µs. The driver output swing is nominally clamped at ±6 V to enable the higher data rates associated with  
this device and to reduce EMI emissions. Even though the driver outputs are clamped, they can handle voltages  
up to ±15 V without damage. All the logic inputs can accept 3.3-V or 5-V input signals.  
The SN75LP1185 complies with the requirements of TIA/EIA-232-F and ITU V.28. These standards are for data  
interchange between a host computer and peripheral at signaling rates up to 20 kbit/s. The switching speeds  
of the SN75LP1185 support rates up to 256 kbit/s.  
The SN75LP1185 is characterized for operation from 0°C to 70°C.  
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of  
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.  
IBM and PC/AT are trademarks of International Business Machines Corporation.  
Copyright 1999, Texas Instruments Incorporated  
PRODUCTION DATA information is current as of publication date.  
Products conform to specifications per the terms of Texas Instruments  
standard warranty. Production processing does not necessarily include  
testing of all parameters.  
1
POST OFFICE BOX 655303 DALLAS, TEXAS 75265  

SN75LP1185DW 替代型号

型号 品牌 替代类型 描述 数据表
SN75LP1185DWRE4 TI

完全替代

LOW-POWER MULTIPLE RS-232 DRIVERS AND RECEIVERS
SN75LP1185DWR TI

完全替代

LOW-POWER MULTIPLE RS-232 DRIVERS AND RECEIVERS

与SN75LP1185DW相关器件

型号 品牌 获取价格 描述 数据表
SN75LP1185DWE4 TI

获取价格

LOW-POWER MULTIPLE RS-232 DRIVERS AND RECEIVERS
SN75LP1185DWG4 TI

获取价格

Low-Power Multiple RS-232 Drivers and Receivers 20-SOIC 0 to 70
SN75LP1185DWR TI

获取价格

LOW-POWER MULTIPLE RS-232 DRIVERS AND RECEIVERS
SN75LP1185DWRE4 TI

获取价格

LOW-POWER MULTIPLE RS-232 DRIVERS AND RECEIVERS
SN75LP1185N TI

获取价格

LOW-POWER MULTIPLE RS-232 DRIVERS AND RECEIVERS
SN75LP1185NE4 TI

获取价格

LOW-POWER MULTIPLE RS-232 DRIVERS AND RECEIVERS
SN75LP1185PW TI

获取价格

LOW-POWER MULTIPLE RS-232 DRIVERS AND RECEIVERS
SN75LP1185PWR TI

获取价格

LOW-POWER MULTIPLE RS-232 DRIVERS AND RECEIVERS
SN75LP1196CDBR TI

获取价格

LINE TRANSCEIVER, PDSO20
SN75LP1196CDBRR TI

获取价格

LINE TRANSCEIVER, PDSO20