SN65LBC031, SN65LBC031Q, SN75LBC031
HIGH-SPEED CONTROLLER AREA NETWORK (CAN) TRANSCEIVERS
SLRS048A – MAY 1998 – REVISED APRIL 2000
D PACKAGE
(TOP VIEW)
SN75LBC031 Meets Standard ISO/DIS
11898 (up to 500 k Baud)
Driver Output Capability at 50 mA
TX
ASC
1
2
3
4
8
7
6
5
GND
CANH
CANL
REF
Wide Positive and Negative Input/output
Bus Voltage Range
V
CC
RX
Bus Outputs Short-Circuit-Protected to
Battery Voltage and Ground
TERMINAL FUNCTIONS
DESCRIPTION
Thermal Shutdown
TERMINAL
Available in Q-Temp Automotive
TX
Transmitter input
Ground
– HighRel Automotive Applications
– Configuration Control/Print Support
– Qualification to Automotive Standards
GND
V
CC
Supply voltage
RX
Receiver output
Reference output
Low side bus output driver
description
REF
CANL
The SN75LBC031 is a CAN transceiver used as
an interface between a CAN controller and the
physical bus for high speed applications of up to
500 kBaud. The device provides transmit
capability to the differential bus and differential
receive capability to the controller. The transmitter
outputs (CANH and CANL), feature internal
transition regulation to provide controlled
symmetry resulting in low EMI emissions. Both
CANH
ASC
High side bus output driver
Adjustable slope control
FUNCTION TABLE
TX
CANH
CANL BUS STATE RX
L
H
L
Dominant
L
High or floating Floating Floating Recessive
L = low, H = high
H
transmitter outputs are fully protected against battery short circuits and electrical transients that can occur on
the bus lines. In the event of excessive device power dissipation the output drivers are disabled by the thermal
shutdown circuitry at a junction temperature of approximately 160°C. The inclusion of an internal pullup resistor
on the transmitter input ensures a defined output during power up and protocol controller reset. For normal
operation at 500 kBaud the ASC terminal is open or tied to GND. For slower speed operation at 125 kBaud the
busoutputtransitiontimescanbeincreasedtoreduceEMIbyconnectingtheASCterminaltoV . The receiver
CC
includes an integrated filter that suppresses the signal into pulses less than 30 ns wide.
The SN75LBC031 is characterized for operation from –40°C to 85°C. The SN65LBC031 is characterized for
operation from –40°C to 125°C. The SN65LBC031Q is characterized for operation over the automotive
temperature range of –40°C to 125°C.
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
Copyright 2000, Texas Instruments Incorporated
PRODUCTION DATA information is current as of publication date.
Products conform to specifications per the terms of Texas Instruments
standard warranty. Production processing does not necessarily include
testing of all parameters.
1
POST OFFICE BOX 655303 • DALLAS, TEXAS 75265