Support &
Community
Product
Folder
Order
Now
Tools &
Software
Technical
Documents
SN65HVD1780-Q1, SN65HVD1781-Q1, SN65HVD1782-Q1
SLLSE49D –SEPTEMBER 2010–REVISED JULY 2017
SN65HVD178x-Q1 Fault-Protected RS-485 Transceivers With 3.3-V to 5-V Operation
1 Features
3 Description
These devices are designed to survive overvoltage
faults such as direct shorts to power supplies, mis-
wiring faults, connector failures, cable crushes, and
tool mis-applications. They are also robust to ESD
events, with high levels of protection to the human-
body-model specification.
1
•
Qualified for Automotive Applications
•
AEC-Q100 Qualified With the Following Results
–
Device Temperature Grade 1:
–40°C to 125°C Ambient Operating
Temperature Range
–
–
Device HBM ESD Classification Level H2
Device CDM ESG Classification Level C3B
These devices combine a differential driver and a
differential receiver, which operate from a single
power supply. In the 'HVD1782, the driver differential
outputs and the receiver differential inputs are
connected internally to form a bus port suitable for
half-duplex (two-wire bus) communication. This port
features a wide common-mode voltage range, making
the devices suitable for multipoint applications over
long cable runs. These devices are characterized
from –40°C to 125°C. These devices are pin-
compatible with the industry-standard SN75176
transceiver, making them drop-in upgrades in most
systems.
•
Bus-Pin Fault Protection to:
–
–
> ±70 V ('HVD1780-Q1, 'HVD1781-Q1)
> ±30 V ('HVD1782-Q1)
•
•
•
•
Operation With 3.3-V to 5-V Supply Range
±16-kV HBM Protection on Bus Pins
Reduced Unit Load for up to 320 Nodes
Failsafe Receiver for Open-Circuit, Short-Circuit
and Idle-Bus Conditions
•
Low Power Consumption
These devices are fully compliant with ANSI TIA/EIA
485-A with a 5-V supply and can operate with a 3.3-V
supply with reduced driver output voltage for low-
power applications. For applications where operation
is required over an extended common-mode voltage
range, see the SN65HVD1785 (SLLS872) data sheet.
–
–
Low Standby Supply Current, 1 μA Maximum
ICC 4-mA Quiescent During Operation
•
•
Pin-Compatible With Industry-Standard SN75176
Signaling Rates of 115 kbps, 1 Mbps, and up to
10 Mbps
(1)
Device Information
2 Applications
NUMBER OF
PART NUMBER
SIGNALING RATE
Automotive Data Links
NODES
SN65HVD1780-Q1 Up to 115 kbps
SN65HVD1781-Q1 Up to 1 Mbps
SN65HVD1782-Q1 Up to 10 Mbps
Up to 320
Up to 320
Up to 64
(1) For all available packages, see the orderable addendum at
the end of the data sheet.
Simplified Schematic
VFAULT up to 70 V
Copyright © 2016, Texas Instruments Incorporated
1
An IMPORTANT NOTICE at the end of this data sheet addresses availability, warranty, changes, use in safety-critical applications,
intellectual property matters and other important disclaimers. UNLESS OTHERWISE NOTED, this document contains PRODUCTION
DATA.