SMBJ Series
600Watts Surface Mount Transient Voltage Suppressor
DO - 214AA(SMB)
4.7± 0.25
Features
• For surface mounted applications in order to optimize
board space
5.4± 0.2
• Low profile package
• Built-in strain relief
• Glass passivated junction
• Low inductance
0.2± 0.05
1.3± 0.2
• Excellent clamping capability
• Repetition Rate (duty cycle): 0.01%
• Fast response time: typically less than 1.0ps from 0 Volts to
BV for unidirectional types
Dimensions in millimeters
• Typical IR less than 1 mA above 10V
• High Temperature soldering: 250˚C/10 seconds at terminals
• Plastic packages has Underwriters Laboratory
Flammability 94V-O
MAXIMUM RATINGS @25˚C AMBIENT TEMPERATURE
AND CHARACTERISTICS (unless otherwise noted)
PARAMETER
VALUE
SYMBOL
UNIT
Mechanical Data
Peak pulse power Dissipation on
10/1000µs waveform
(note 1,2, FIG.1)
Min
600
P
Watts
PPM
• Case:JEDEC DO214AA. Molded plastic over glass passivated
junction
Peak pulse current of on 10\1000µs
waveform (note 1, FIG.3)
I
PPM
Amps
Amps
SEE TABLE 1
100
• Terminal: Solder plated, solderable per MIL-STD-750
Method 2026
Peak forward Surge Current, 8.3ms
Single Half SIne Wave Superimposed
on Rated Load, (JEDEC Method)
(note 2.3)
I
• Polarity. Color band denotes positive end(cathode) except
Bidirectional
PSM
• Standard Packaging: 12mm tape(EIA STF RS-481)
• Weight: 0.003 ounce, 0.093 gram
-55 to +150
-55 to +150
Operating junction and Storage
Temperature Range
T
T
°C
j, sTG
Note 1. Non-repetitive current pulse, per Fig.3 and derated above
T = 25˚C per Fig.2
Note 2. Mounted on 5.0mm (0.03mm thick) Copper Pads to each
terminal
Note 3. 8.3 ms single half sine-wave, or equivalent square wave,
Duty cycle= 4 pulses per minute
A
DEVICES FOR BIPOLAR APPLICATIONS
For Bidirectional use C or CA Suffix for types SMBJ5.0 thru types
SMBJ110(e.g. SMBJ5.OC, SMBJ170CA)
2
Electrical characteristics apply in both directions
http://www.luguang.cn
mail:lge@luguang.cn