105°C SNAP–IN ALUMINUM ELECTROLYTIC
SIT SERIES
SUBMINIATURE
MECHANICAL SPECIFICATIONS
(SIT: High Temperature Snap–in)
Marking:
The SIT Snap–in series subminiature aluminum electrolytic ca-
pacitors are especially suitable for applications requiring high ca-
pacitance, low cost, and very small size. In fact, you’ll find these
capacitors in some of the most demanding applications, from
precision medical electronics and automobiles to the newest
personal computers and disk drives.
Consists of series type, nominal capacitance, rated
voltage, temperature range, anode and/or cathode
identification, vendor identification.
Recommended Cleaning Solvents:
Chlorofluorocarbon solvents used to remove flux from
printed circuit boards can penetrate the capacitor end–
seals, cause corrosion when voltage is applied and ca-
pacitor failure. Avoid halogenated solvents and consid-
er these alternatives: Clean the capacitors with
water/detergent or cleaning solvents free of halogen
groups such as alcohol or terpene solution, or mount
the capacitor after board cleaning.
They operate over a broad temperature range and are available
in either blister pack or bulk.
RATINGS
Capacitance Range: 100µf to 10,000µf
Tolerance: ±20%
Voltage Range: 50V to 250V
CASE SIZE AND DIMENSIONS:
PERFORMANCE SPECIFICATIONS
Operating Temperature Range:
SIT SERIES
10.0
–40°C to +105°C (–40°F to +221°F)
Leakage Current: I ≤ 3 x √CV (measured after
5 minutes @ rated voltage and +20°C (+68°F)
Vinyl Sleeve
Polarity Bar
Safety Vent
I = Leakage Current (µA)
C = Nominal Capacitance (µf)
V = Rated Voltage (V)
L + 2
Max
6.3 ±1
D Ø + 1
Max
Capacitance Tolerance (M): ±20%
measured at +20°C (+68°F), 120HZ
2 ±0.1
Dia
10 ±0.1
+0.2
–0.1
0.8
Surge Voltage:
2.0 Max
DC Rated Voltage
Surge Voltage
50
63
200
250
250
300
6.3 ±1
4.0
1.5 ±0.2
Load Life: 2000 ±12Hrs @ Max rated temperature
D Ø
PC Board Mounting Holes
and rated voltage
Terminal
Leakage Current: Within values specified above
Dissipation Factor: Within ±150% of specified value
Shelf Life: 1000 ±6Hrs @ Max rated temperature,
ORDERING INFORMATION
no voltage applied
SIT
1000
M
50
Leakage Current: Within ±200% of specified value
Dissipation Factor: Within ±150% of specified value
Capacitance Change Max: Within ±20% of initial value
Series
Capacitance
Tolerance
Voltage
14
NTE Electronics, Inc. D Voice (800) 631–1250 (973) 748–5089 D FAX (973) 748–6224 D http://www.nteinc.com