SiP12108, SiP12108A
www.vishay.com
Vishay Siliconix
2.8 V to 5.5 V Input
5 A Synchronous Buck Regulator
DESCRIPTION
FEATURES
• 2.8 V to 5.5 V input voltage
The SiP12108 is a high frequency current-mode constant
on-time (CM-COT) synchronous buck regulator with
integrated high-side and low-side power MOSFETs. Its
power stage is capable of supplying 5 A continuous current
at 4 MHz switching frequency. This regulator produces an
adjustable output voltage down to 0.6 V from 2.8 V to 5.5 V
input rail to accommodate a variety of applications,
including computing, consumer electronics, telecom, and
industrial.
• Adjustable output voltage down to 0.6 V
• 5 A continuous output current
• Programmable switching frequency up to 4 MHz
• 95 % peak efficiency
• Stable with any capacitor. No external ESR
network required.
• Ultrafast transient response
• Selectable power saving (PSM) mode or forced
continuous mode
SiP12108’s CM-COT architecture delivers ultra-fast
transient response with minimum output capacitance and
tight ripple regulation at very light load. The part is stable
with any capacitor type and no ESR network is required for
loop stability. The device also incorporates a power saving
scheme that significantly increases light load efficiency.
•
1 % accuracy of VOUT setting
• Pulse-by-pulse current limit
• Scalable with SiP12107 - 3 A
• SiP12108 is fully protected with OTP, SCP, UVP, OVP
• SiP12108A is fully protected with OTP, SCP, OVP
• PGOOD Indicator
The SiP12108 integrates a full protection feature set,
including output overvoltage protection (OVP), output under
voltage protection (UVP) and thermal shutdown (OTP). The
“A” version of the device, SiP12108A, does not have the
UVP feature. They also incorporate UVLO for the input rail
and an internal soft-start ramp.
• PowerCAD Simulation software available at
vishay.transim.com/login.aspx
• Material categorization: For definitions of compliance
please see www.vishay.com/doc?99912
The SiP12108 is available in lead (Pb)-free power enhanced
3 mm x 3 mm QFN-16 package.
APPLICATIONS
• Point of load regulation for low-power processors,
network processors, DSPs, FPGAs, and ASICs
• Low voltage, distributed power architectures with
3.3 V or 5 V rails
• Computing, broadband, networking, LAN/WAN, optical,
test and measurement
• A/V, high density cards, storage, DSL, STB, DVR, DTV,
Industrial PC
TYPICAL APPLICATION CIRCUIT
POWER SAVE MODE
ENABLE
POWER GOOD
PGOOD EN AUTO
VOUT
INPUT = 2.8 V to 5.5 V
VIN
LX
VOUT
VFB
AVIN
GMO
RON
PGND
AGND
Fig. 1 - Typical Application Circuit for SiP12108
S13-2257-Rev. B, 11-Nov-13
Document Number: 62699
1
For technical questions, contact: analogswitchtechsupport@vishay.com
THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT
ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000