Broadband & Voice Telephony Solutions
I N N O V A T I V E , F L E X I B L E , G L O B A L , E C O N O M I C A L
K E Y P R O D U C T S
Si3216 ProSLIC® and Si3220 Dual ProSLIC
• Integrated CMOS SLIC/codec
• On-chip tracking dc-dc converter
controller (Si3216)
• Wideband audio codec (Si3216)
• Software programmable for global compliance
• Internal ringing up to 100 VPK
• DTMF generation/decoding (Si3220)
• FSK caller ID generation
• On-chip GR-909 line diagnostics
Si3050 Voice DAA
• Integrated codec
• Globally compliant
• 16 selectable ac terminations
• Programmable hybrid
• Line voltage/current monitoring
• Loop start/ground start support
• PCM/SPI or GCI interface
• µ-law or A-law companding
• Greater than 5 kV line isolation
Si3110 ADSL2+ AFE
• Integrated line driver, codec, hybrid and VCXO
• Supports G.dmt, Annex A/B/C, ADSL2, ADLS2+
and SHDSL
• 1 W typical power consumption
• Only 3.3 V and 5 V power supplies needed
• Programmable hybrid improves rate/reach
D E S C R I P T I O N
Silicon Laboratories’ broad array of mixed-signal communication devices brings
unsurpassed integration, performance and value to broadband access and voice
telephony solutions. These integrated circuits provide global compliance using a single
hardware solution while reducing the PCB footprint and total solution bill-of-materials.
Optimized for customer premise equipment (CPE) applications, these best-in-class
solutions address global telecom standards through a high degree of programmability.
Additionally, these products are designed using standard digital CMOS. This reduces
power and cost while increasing system performance and flexibility through increased
integration without sacrificing system performance.
Si2457 ISOmodem®
• Complete controller-based embedded modem
• Pin-compatible solutions from
2400 bps to 56 kbps
• AT command UART or parallel interface
•
Line-in-use and parallel phone intrusion detection
• Globally compliant line interface meets all PTT
standards worldwide
• More than 5 kV line isolation
S Y S T E M B E N E F I T S
• Small footprints save board space and discrete component cost
• Requires only 3.3 V and 5 V power supplies and eliminates the need for costly
additional power supplies
S O L U T I O N S G U I D E
• Reduces system power consumption
COMPLETE MIXED-SIGNAL
SOLUTIONS FOR BROADBAND
ACCESS APPLICATIONS
• Line voltage/current monitoring for remote system provisioning and fault detection
• Globally compliant solutions enable a single design for all countries
• PCM/SPI or GCI digital interfaces for FXS and FXO ports
A P P L I C A T I O N S
• ADSL/cable modems
• Pair gain systems
• Line cards
• Integrated access devices (IADs)
• PBX systems
• Computer telephony
• Voice over IP (VoIP) gateways and routers