SH3100
Supervisory IC with I2C
Interface and PWM
POWER MANAGEMENT
Description
The SH3100 is a size, power, and cost-saving solution for microprocessor support functions. It is intended to replace
a number of peripheral devices normally used in conjunction with a microprocessor. Its prime function is to provide
an accurate and stable clock source which can be started up and shut down very quickly to enable it to be used in a
pulsed fashion for very low power applications.
The SH3100 consumes very little power when in standby, and it provides a stable output clock in less than 2μs. This
allows it to outperform ceramic resonators and crystals requiring much longer start-up times.
Features
ꢀMaster HFDCO oscillator which can be programmed to ꢀPeriodic interrupt timer (PIT) with a 30μs resolution
between 8MHz and 33.5MHz with 2kHz resolution
up to 36 hours
ꢀA 32.768kHz crystal oscillator with 5-bit programma-
ble padding capacitance giving a frequency adjust-
ment resolution of 4ppm
ꢀReal time clock with 1/256 second resolution up to
Year 2099
ꢀSpread spectrum option on the output clock
ꢀTwo clock outputs, each of which can be powered inde
pendently from VDD or VBAK and can operate either
in-phase or in complementary mode
ꢀBattery backup facility, which maintains register con-
tents less than 2μA consumption
ꢀAn internal oscillator which is fuse-calibrated to
provide a 32.768kHz clock source, accuracy is better
than ±3% over temperature and supply voltage
ꢀ1.7V to 5.5V operating range on the main VDD supply
ꢀ0.9V to 5.5V operating range on the battery backup
supply (VBAK)
ꢀ96-bit electrically programmable non-volatile fuse
memory array
ꢀEdge-triggered, level-sensitive, and toggling interrupt
output (INT)
ꢀ7-bit programmable threshold reset comparator (VBO)
between 1.7V and 4V with 24mV resolution
ꢀGeneral-purpose I/O option on the interrupt pin (INT)
ꢀProgrammable reset duration between 6ms and 5.3
ꢀLow power, low dropout voltage regulator (LDO) output
seconds
on PWM pin
ꢀLess than 10μA standby current and less than 12mA
ꢀSwitched mode boost, bootstrap boost, and buck
maximum operating current (excluding LDO load)
regulation control
ꢀI2C interface with 3-bit fuse-settable address complies
with I2C fast mode specification
ꢀ56 bytes of control registers including a 9-byte
scratchpad
ꢀGeneral-purpose 8-bit DAC and Comparator
ꢀGeneral-purpose PWM & PDM output
ꢀSmall 3mm x 3mm 16-lead MLP package
Covered by United States Patent 6,903,986
Semtech, the Semtech logo, MicroBuddy, μBuddy, and μB are marks
of Semtech Corporation. All other marks belong to their respective
ꢀProgrammable watchdog counter with a 7.8ms
owners.
resolution up to 8 seconds delay
www.semtech.com
May 22, 2006
1