Preliminary
SF2258E
• Low-loss RF SAW Filter
• Surface-mount 3.0 x 3.0 x 1.3 mm Package
• Complies with Directive 2002/95/EC (RoHS)
2655 MHz
Pb
SAW Filter
Absolute Maximum Ratings
Rating
Value
10
Units
dBm
V
Input Power Level
DC Voltage on any Non-ground Terminal
Operating Temperature Range
Storage Temperature Range in Tape and Reel
3
-40 to +85
-40 to +85
°C
°C
°C
Solder Reflow Temperature, 10 seconds, 5 cycles maximum
260
SM3030-6
Electrical Characteristics
Characteristic
Sym
Notes
Min
Typ
Max
Units
F
Center Frequency
2655
2.3
MHz
dB
C
IL
Maximum Insertion Loss, 2624 to 2690 MHz
Amplitude Ripple, 2624 to 2690 MHz
VSWR, 2624 to 2690 MHz
Attenuation Referenced to 0 dB:
DC to 2100 MHz
3.6
2.0
dB
0.8
P-P
1.9:1
2.5:1
25
27
30
15
31
34
37
22
50
50
2100 to 2515 MHz
dB
2770 to 4000 MHz
4000 to 5000 MHz
Z
Source Impedance
S
Ω
Z
Load Impedance
L
V
ESD Voltage (machine model)
50
Case Style
SM3030-6 3.0 x 3.0 mm Nominal Footprint
A05, YWWS
Lid Symbolization (Y=year, WW=week, S=shift) dot=pin 1 indicator
Standard Reel Quantity
Reel Size 7 Inch
Reel Size 13 Inch
500 Pieces/Reel
3000 Pieces/Reel
CAUTION: Electrostatic Sensitive Device. Observe precautions for handling.
Notes:
1.
Unless noted otherwise, all specifications apply over the operating temperature range with filter soldered to the specified demonstration board with impedance
matching to 50 Ω and measured with 50 Ω network analyzer.
2.
3.
Unless noted otherwise, all frequency specifications are referenced to the nominal center frequency, fc.
Rejection is measured as attenuation below the minimum IL point in the passband. Rejection in final user application is dependent on PCB layout and external
impedance matching design. See Application Note No. 42 for details.
4.
5.
6.
"LRIP" or "L" after the part number indicates "low rate initial production" and "ENG" or "E" indicates "engineering prototypes."
The design, manufacturing process, and specifications of this filter are subject to change.
Either Port 1 or Port 2 may be used for either input or output in the design. However, impedances and impedance matching may vary between Port 1 and Port
2, so that the filter must always be installed in one direction per the circuit design.
US and international patents may apply.
RFM, stylized RFM logo, and RF Monolithics, Inc. are registered trademarks of RF Monolithics, Inc
7.
8.
www.RFM.com E-mail: info@rfm.com
©2010-2011 by RF Monolithics, Inc.
Page 1 of 6
SF2258E - 1/3/11