SF2233E
• Low-loss RF SAW Filter
• Miniature 3 x 3 mm SMD Package
• Complies with Directive 2002/95/EC (RoHS)
1882.5 MHz
SAW Filter
Pb
Absolute Maximum Ratings
Rating
Value
+12
Units
dBm
V
Input Power Level
DC Voltage on any Non-grounded Terminal
Operating Temperature Range
Storage Temperature Range in Tape and Reel
3
-40 to +85
-40 to +85
265
°C
°C
°C
Maximum Soldering Profile, 5 cycles/10 seconds maximum
SM3030-6
Electrical Characteristics
Characteristic
Sym
Notes
Min
Typ
Max
Units
f
Center Frequency
1882.5
1.2
MHz
dB
C
IL
Minimum Insertion Loss, 1850 to 1915 MHz
Amplitude Ripple, 1850 to 1915 MHz
Input/Output Return Loss, 1850 to 1915 MHz
Attenuation, Referenced to 0 dB:
800 to 1400 MHz
2.5
3.0
MIN
dB
2.0
P-P
6.0
6.5
dB
25
30
6
35
32
15
25
34
30
32
30
50
50
1480 to 1640 MHz
1930 to 1940 MHz
1940 to 1950 MHz
20
32
25
25
25
dB
1972 to 2050 MHz
2110 to 2170 MHz
2300 to 2400 MHz
2400 to 3000 MHz
Z
Source Impedance
Ω
Ω
S
Z
Load Impedance
L
Case Style
SM3030-6 3.0 x 3.0 mm Nominal Footprint
968, YWWS
Lid Symbolization (Y=year, WW=week, S=shift) dot=pin 1 indicator
Standard Reel Quantity
Reel Size 7 inch
Reel Size 13 inch
500 Pieces/Reel
3000 Pieces/Reel
Electrical Connections
Connection
Input
Terminals
2
5
5
0
o
h
m
5
0
o
h
m
S
A
W
F
i
l
t
e
r
2
5
Output
1
,
3
,
4
,
6
Case Ground
All others
CAUTION: Electrostatic Sensitive Device. Observe precautions for handling.
Notes:
1.
Unless noted otherwise, all specifications apply over the operating temperature range with filter soldered to the specified demonstration board with impedance
matching to 50 Ω and measured with 50 Ω network analyzer.
2.
3.
Unless noted otherwise, all frequency specifications are referenced to the nominal center frequency, fc.
Rejection is measured as attenuation below the minimum IL point in the passband. Rejection in final user application is dependent on PCB layout and external
impedance matching design. See Application Note No. 42 for details.
4.
5.
The design, manufacturing process, and specifications of this filter are subject to change.
Either Port 1 or Port 2 may be used for either input or output in the design. However, impedances and impedance matching may vary between Port 1 and Port
2, so that the filter must always be installed in one direction per the circuit design.
US and international patents may apply.
RFM, stylized RFM logo, and RF Monolithics, Inc. are registered trademarks of RF Monolithics, Inc.
6.
7.
www.RFM.com E-mail: info@rfm.com
©2010 by RF Monolithics, Inc.
Page 1 of 5
SF2233E - 11/18/10