Preliminary
SF2223D
• High Performance SAW Filter
• 3.8 x 3.8 x 1.4 mm Surface-mount Package
• Complies with Directive 2002/95/EC (RoHS)
184.32 MHz
SAW Filter
Pb
Absolute Maximum Ratings
Rating
Value
+10
Units
dBm
VDC
°C
Maximum Incident Power in Passband
Maximum DC Voltage Between any Two Active Terminals
Storage Temperature Range in Tape and Reel
30
-40 to +85
Suitable for Lead-free Soldering - Maximum Soldering Profile
260 °C for 30 s
SM3838-8
Electrical Characteristics
Characteristic
Sym
fC
Notes
Min
Typ
Max
Units
Nominal Center Frequency
Minimum Insertion Loss
1 dB Bandwidth
184.32
8.5
MHz
dB
ILMIN
BW1
10.0
30
32
MHz
dBP-P
nsP-P
Amplitude Ripple, 169.32 to 199.32 MHz
Group Delay Ripple, 169.32 to 199.32 MHz
Rejection referenced to ILMIN:
1.00 to 137.88 MHz
0.6
1.0
50
18
45
16.5
16.5
45
60
60
60
50
149.32 MHz
dB
219.32 MHz
261.48 to 600.00 MHz
Case Style
SM3838-8 3.8 x 3.8 mm Nominal Footprint
959, YWWS
Lid Symbolization, Y=year, WW=week, S=shift, Dot=pin 1 indicator
Standard Reel Quantity
Reel Size 7 Inch
Reel Size 13 Inch
500 Pieces/Reel
3000 Pieces/Reel
Electrical Connections
Connection
Terminals
Balanced Input Option
Single-ended Input Option
Output
1 and 2
1
5
Case Ground
All others
CAUTION: Electrostatic Sensitive Device. Observe precautions for handling.
Notes:
1.
Unless noted otherwise, all specifications apply over the operating temper-
ature range with filter soldered to the specified demonstration board with
impedance matching to 50 and measured with 50 network analyzer.
Unless noted otherwise, all frequency specifications are referenced to the
nominal center frequency, fc.
and "ENG" or "E" indicates "engineering prototypes."
5.
6.
The design, manufacturing process, and specifications of this filter are
subject to change.
2.
3.
Either Port 1 or Port 2 may be used for either input or output in the design.
However, impedances and impedance matching may vary between Port 1
and Port 2, so that the filter must always be installed in one direction per
the circuit design.
US and international patents may apply.
RFM, stylized RFM logo, and RF Monolithics, Inc. are registered
trademarks of RF Monolithics, Inc.
Rejection is measured as attenuation below the minimum IL point in the
passband. Rejection in final user application is dependent on PCB layout
and external impedance matching design. See Application Note No. 42
for details.
7.
8.
4.
"LRIP" or "L" after the part number indicates "low rate initial production"
www.RFM.com E-mail: info@rfm.com
© 2010-2011 by RF Monolithics, Inc.
Page 1 of 7
SF2223D - 11/10/11