SF2199E
• Surface Mount 3.0 x 3.0 mm Package
• Complies with Directive 2002/95/EC (RoHS)
Pb
787 MHz
SAW Filter
Absolute Maximum Ratings
Rating
Value
20
Units
dBm
V
Input Power Level
DC Voltage on any Non-ground Terminal
Operating Temperature Range
Storage Temperature Range in Tape and Reel
3
-40 to +85
-40 to +85
°C
°C
Suitable for Lead-free Soldering - Maximum Soldering Profile
260 °C for 30 s
SM3030-6
Electrical Characteristics
Characteristic
Sym
fC
Notes
Min
Typ
787
2.4
0.6
10
Max
Units
Center Frequency
MHz
Insertion Loss, 776 to 798 MHz
Amplitude Ripple, 776 to 798 MHz
Return Loss, 776 to 798 MHz
Attenuation, 0 dB Reference:
10 to 746 MHz
IL
3.0
1.5
dB
7
30
30
40
25
54
52
62
31
50
50
746 to 756 MHz
dB
1056 to 1078 MHz
1078 to 2700 MHz
ZS
ZL
Source Impedance
Load Impedance
Case Style
SM3030-6 3.0 x 3.0 mm Nominal Footprint
929, YWWS
Lid Symbolization (Y=year, WW=week, S=shift) dot=pin 1 indicator
Standard Reel Quantity
Reel Size 7 Inch
Reel Size 13 Inch
500 Pieces/Reel
3000 Pieces/Reel
Electrical Connections
Connection
Input
Terminals
2
5
1
6
Output
0
o
h
m
5
0
o
h
m
5
2
Case Ground
All others
L
o
a
d
S
o
u
r
c
e
4
3
(
b
o
t
t
o
m
v
i
e
w
)
CAUTION: Electrostatic Sensitive Device. Observe precautions for handling.
Notes:
1.
Unless noted otherwise, all specifications apply over the operating temperature range with filter soldered to the specified demonstration board with impedance
matching to 50 and measured with 50 network analyzer.
2.
3.
Unless noted otherwise, all frequency specifications are referenced to the nominal center frequency, fc.
Rejection is measured as attenuation below the minimum IL point in the passband. Rejection in final user application is dependent on PCB layout and external
impedance matching design. See Application Note No. 42 for details.
4.
5.
6.
"LRIP" or "L" after the part number indicates "low rate initial production" and "ENG" or "E" indicates "engineering prototypes."
The design, manufacturing process, and specifications of this filter are subject to change.
Either Port 1 or Port 2 may be used for either input or output in the design. However, impedances and impedance matching may vary between Port 1 and Port
2, so that the filter must always be installed in one direction per the circuit design.
7.
8.
US and international patents may apply.
RFM, stylized RFM logo, and RF Monolithics, Inc., are registered trademarks of RF Monolithics, Inc.
www.RFM.com E-mail: info@rfm.com
© 2009-2012 by RF Monolithics, Inc.
Page 1 of 5
SF2199E - 4/25/12