Preliminary
SF2189A
• Precision IF SAW Filter
• Hermetic 13.3 x 6.5 mm Surface-mount Case
• Complies with Directive 2002/95/EC (RoHS)
140 MHz
Pb
SAW Filter
Absolute Maximum Ratings
Rating
Value
+10
Units
dBm
VDC
°C
Maximum Incident Power in Passband
Maximum DC Voltage between any Two Terminals
Storage Temperature Range in Tape and Reel
Suitable for Lead-free Soldering - Maximum Soldering Profile
3
-40 to +85
SM13365-12
260°C for 30 s
Electrical Characteristics
Characteristic
Sym
Notes
Min
Typ
140
11.3
33.0
35.0
42.4
0.6
Max
Units
F
Center Frequency
1
MHz
dB
C
IL
Minimum Insertion Loss
1
1
13.0
MIN
BW
1 dB Bandwidth
30.0
32.0
MHz
MHz
MHz
1
BW
3 dB Bandwidth
1
3
BW
35 dB Bandwidth
1
44.0
1.2
35
Passband Amplitude Ripple, 80% of 3 dB Bandwidth
Passband Group Delay Ripple, 80% of 3 dB Bandwidth
dB
1, 2, 3
1, 2, 3
1,2,3
1, 2, 3
1
P-P
ns
50
120
P-P
Passband Absolute Group Delay
Passband Phase Linearity, 80% of 3 dB Bandwidth
Operating Temperature
0.55
5
µs
deg
14
P-P
-20
+80
°C
ppm/°C
ohm
Frequency Temperature Coefficient
Source Impedance
-94
50
50
Load Impedance
ohm
Case Style
SM13365-12 13.3 x 6.5 mm Nominal Footprint
RFM SF2189A YYWW
Lid Symbolization (YY = year, WW = week)
CAUTION: Electrostatic Sensitive Device. Observe precautions for handling.
Notes:
1.
Unless noted otherwise, all specifications apply over the operating temperature range with filter soldered to the specified demonstration board with impedance
matching to 50 Ω and measured with 50 Ω network analyzer.
2.
3.
Unless noted otherwise, all frequency specifications are referenced to the nominal center frequency, fc.
Rejection is measured as attenuation below the minimum IL point in the passband. Rejection in final user application is dependent on PCB layout and external
impedance matching design. See Application Note No. 42 for details.
4.
5.
6.
7.
Part to part absolute delay measurement records the absolute delay mean across 1 dB passband.
"LRIP" or "L" after the part number indicates "low rate initial production" and "ENG" or "E" indicates "engineering prototypes.”
The design, manufacturing process, and specifications of this filter are subject to change.
Either Port 1 or Port 2 may be used for either input or output in the design. However, impedances and impedance matching may vary between Port 1 and Port
2, so that the filter must always be installed in one direction per the circuit design.
8.
US and international patents may apply.
www.RFM.com E-mail: info@rfm.com
©2009 by RF Monolithics, Inc.
Page 1 of 6
SF2189A - 7/1/09