SF2178A
• Precision IF SAW Filter
• Hermetic 13.3 x 6.5 mm Surface-mount Case
• Complies with Directive 2002/95/EC (RoHS)
168 MHz
Pb
SAW Filter
Absolute Maximum Ratings
Rating
Value
+10
Units
dBm
VDC
°C
Maximum Incident Power in Passband
Maximum DC Voltage Between any 2 Terminals
Storage Temperature Range
30
-40 to +85
Suitable for Lead-free Soldering - Maximum Soldering Profile
260°C for 30 s
SM13365-12
Electrical Characteristics
Characteristic
Sym
Notes
Min
Typ
168
Max
Units
f
Center Frequency
1
1
1
1
1
1
MHz
MHz
MHz
MHz
MHz
dB
C
BW
20.9
22.4
181.7
155.1
12.2
0.76
0.85
54
1 dB Bandwidth
20.0
1
BW
3 dB Bandwidth
3
Upper -35 dB Band Edge
Lower -35 dB Band Edge
182.0
154
-40
Insertion Loss
IL
13.5
1.0
1
Passband Ripple (p-p)
158 to 178 MHz
dB
Absolute Group Delay
168 MHz
1, 2, 3
1
µs
Group delay ripple (p-p)
Operating Temperature
158 to 178 MHz
160
+85
ns
°C
Source Impedance
50
2.3
50
ohm
VSWR to Source (Matching Network)
Load Impedance
159.5 to 168.5 MHz
159.5 to 168.5 MHz
ohm
VSWR to Load (Matching Network)
Frequency Temperature Coefficient
2.2
-72
ppm/°C
Impedance Matching to 50 Ω Unbalanced
Case Style
External L-C
SM13365-12 13.3 x 6.5 mm Nominal Footprint
RFM SF2178A YYWW
Lid Symbolization (YY = year, WW = week)
CAUTION: Electrostatic Sensitive Device. Observe precautions for handling.
Notes:
1.
Unless noted otherwise, all specifications apply over the operating temperature range with filter soldered to the specified demonstration board with impedance
matching to 50 Ω and measured with 50 Ω network analyzer.
2.
3.
Unless noted otherwise, all frequency specifications are referenced to the nominal center frequency, fc.
Rejection is measured as attenuation below the minimum IL point in the passband. Rejection in final user application is dependent on PCB layout and external
impedance matching design. See Application Note No. 42 for details.
4.
5.
6.
7.
Part to part absolute delay measurement records the absolute delay mean across 1 dB passband.
"LRIP" or "L" after the part number indicates "low rate initial production" and "ENG" or "E" indicates "engineering prototypes.”
The design, manufacturing process, and specifications of this filter are subject to change.
Either Port 1 or Port 2 may be used for either input or output in the design. However, impedances and impedance matching may vary between Port 1 and Port
2, so that the filter must always be installed in one direction per the circuit design.
8.
US and international patents may apply.
www.RFM.com E-mail: info@rfm.com
©2008 by RF Monolithics, Inc.
Page 1 of 5
SF2178A - 7/7/09