SF2146D
• 3.8 X 3.8 X 1.0 mm Surface Mount Case
• Complies with Directive 2002/95/EC (RoHS)
Pb
415.0 MHz
SAW Filter
Absolute Maximum Ratings
Rating
Value
+15
Units
dBm
VDC
°C
Maximum Incident Power in Passband
Maximum DC Voltage on any Non-ground Terminal
Storage Temperature Range in Tape and Reel
Suitable for Lead-free Soldering - Maximum Soldering Profile
TBD
-45 to +85
260 °C for 30 s
SM3838-8
Electrical Characteristics
Characteristic
Sym
Notes
Min
Typ
415
32
Max
Units
f
Center Frequency
3 dB Bandwidth
1
MHz
MHz
dB
O
BW
25
3
Maximum Insertion loss at 415 MHz
Amplitude Ripple, 403 to 427 MHz
Attenuation:
IL
MAX
4.0
1.5
4.5
2.0
dB
P-P
90 to 290 MHz
41
32
42
30
17
13
35
30
50
40
290 to 328 MHz
328 to 350 MHz
50
350 to 375 MHz
40
dB
375 to 390 MHz
20
445 to 475 MHz
20
475 to 485 MHz
40
485 to 900 MHz
36
Input/Output Impedance
Operating Temperature
50 / 100
Ω
-30
+85
°C
Case Style
SM3838-8 3.8 x 3.8 mm Nominal Footprint
777, YWWS
Lid Symbolization (Y=year, WW=week, S=shift) dot=pin 1 indicator
Standard Reel Quantity
Reel Size 7 Inch
Reel Size 13 Inch
500 Pieces/Reel
3000 Pieces/Reel
CAUTION: Electrostatic Sensitive Device. Observe precautions for handling.
Notes:
1.
Unless noted otherwise, all specifications apply over the operating temperature range with filter soldered to the specified demonstration board with impedance
matching to 50 Ω and measured with 50 Ω network analyzer.
2.
3.
Unless noted otherwise, all frequency specifications are referenced to the nominal center frequency, fc.
Rejection is measured as attenuation below the minimum IL point in the passband. Rejection in final user application is dependent on PCB layout and external
impedance matching design. See Application Note No. 42 for details.
4.
5.
The design, manufacturing process, and specifications of this filter are subject to change.
Either Port 1 or Port 2 may be used for either input or output in the design. However, impedances and impedance matching may vary between Port 1 and Port
2, so that the filter must always be installed in one direction per the circuit design.
US and international patents may apply.
RFM, stylized RFM logo, and RF Monolithics, Inc. are registered trademarks of RF Monolithics, Inc.
6.
7.
www.RFM.com E-mail: info@rfm.com
©2009-2010 by RF Monolithics, Inc.
Page 1 of 4
SF2146D - 5/12/10