®
SF2049E
•
•
Steep Roll-off Filter for 915 MHz ISM band
Complies with Directive 2002/95/EC (RoHS)
Pb
915.00 MHz
SAW Filter
Absolute Maximum Ratings
Rating
Value
15
Units
dBm
V
Input Power Level
DC Voltage
5
Operating Temperature Range
Storage Temperature Range
-40 to +85
-40 to +85
°C
°C
SM3030-6
Electrical Characteristics
Characteristic
Sym
Notes
Min
Typ
Max
Units
F
Center Frequency
915.00
2.2
MHz
C
Insertion Loss within 902 ~ 928 MHz
Amplitude Ripple (p-p) within 902 ~ 928 MHz
VSWR within 902 ~ 928 MHz
3.5
2.0
2.3
IL
0.6
1.6
Attenuation (Reference level from 0dB)
D.C. ~ 800 MHz
50
63.0
48.0
39.0
65.0
28.0
50
dB
800 ~ 880 MHZ
960 ~ 1080 MHZ
40.0
32.0
45.0
22.0
1080 ~ 1500 MHZ
1500 ~ 3000 1500 MHZ
Z
Source Impedance
Load Impedance
W
W
S
Z
50
L
Case Style
SM3030-6 3.0 x 3.0 mm Nominal Footprint
541, YWWS
Lid Symbolization (Y=year, WW=week, S=shift) dot=pin 1 indicator
Standard Reel Quantity
Reel Size 7 Inch
Reel Size 13 Inch
1000 Pieces/Reel
3000 Pieces/Reel
Electrical Connections
Connection
Port 1
Terminals
2
5
Port 2
Case Ground
All others
Notes:
5. The design, manufacturing process, and specifications of this filter
are subject to change.
6. Either Port 1 or Port 2 may be used for either input or output in the
design. However, impedances and impedance matching may vary
between Port 1 and Port 2, so that the filter must always be installed
in one direction per the circuit design.
1. Unless noted otherwise, all specifications apply over the operating
temperature range with filter soldered to the specified demonstration
board with impedance matching to 50 W and measured with 50 W net-
work analyzer.
2. Unless noted otherwise, all frequency specifications are referenced to
the nominal center frequency, fc.
7. US and international patents may apply.
3. Rejection is measured as attenuation below the minimum IL point in
the passband. Rejection in final user application is dependent on
PCB layout and external impedance matching design. See Applica-
tion Note No. 42 for details.
8. RFM, stylized RFM logo, and RF Monolithics, Inc. are registered
trademarks of RF Monolithics, Inc.
9. ©Copyright 1999, RF Monolithics Inc.
10. Electrostatic Sensitive Device. Observe precautions for handling.
4. "LRIP" or "L" after the part number indicates "low rate initial produc-
tion" and "ENG" or "E" indicates "engineering prototypes."
RF Monolithics, Inc.
RFM Europe
Phone: (972) 233-2903
Phone: 44 1963 251383
Fax: (972) 387-8148
Fax: 44 1963 251510
E-mail: info@rfm.com
http://www.rfm.com
SF2049E-9/14/07
Page 1 of 4
©1999 by RF Monolithics, Inc. The stylized RFM logo are registered trademarks of RF Monolithics, Inc.