®
SF2008D
•
•
•
RF Filter for Pager Applications
High Rejection Out of Band
Complies with Directive 2002/95/EC (RoHS)
930.5 MHz
SAW Filter
Pb
Absolute Maximum Ratings
Rating
Value
+0
Units
dBm
VDC
°C
Maximum Incident Power in Passband
Max. DC voltage between any 2 Terminals
Storage Temperature Range
30
-40 to +85
Suitable for lead-free soldering - Max. Soldering Profile
260°C for 30 s
SM3838-6
Electrical Characteristics
Characteristic
Sym
Notes
1
Min
Typ
930.5
Max
Units
f
Nominal 1 dB Center Frequency
MHz
dB
C
Passband
Insertion Loss across 928.5 to 932.5 MHz
Amplitude Variation over fc ±2 MHz
4.5
2.0
IL
1, 2
dB
P-P
Rejection
400 to 880 MHz
884.8 to 890.2 MHZ
906.8 to 911.2 MHZ
980 to 1300 MHZ
35
40
30
35
-20
1, 2, 3
1
dB
°C
T
Operating Temperature Range
+70
A
Impedance at Fc
Input
50 - j57 ohm
50 - j57 ohm
Output
Case Style
SM3838-6 3.8 x 3.8 mm Nominal Footprint
455, YWWS
Lid Symbolization (Y=year, WW=week, S=shift) dot=pin 1 indicator
Standard Reel Quantity
Reel Size 7 Inch
Reel Size 13 Inch
1000 Pieces/Reel
3000 Pieces/Reel
Electrical Connections
Connection
Port 1
Terminals
2
5
Port 2
Case Ground
All others
Notes:
5. The design, manufacturing process, and specifications of this filter
are subject to change.
6. Either Port 1 or Port 2 may be used for either input or output in the
design. However, impedances and impedance matching may vary
between Port 1 and Port 2, so that the filter must always be installed
in one direction per the circuit design.
1. Unless noted otherwise, all specifications apply over the operating
temperature range with filter soldered to the specified demonstration
board with impedance matching to 50 W and measured with 50 W net-
work analyzer.
2. Unless noted otherwise, all frequency specifications are referenced to
the nominal center frequency, fc.
7. US and international patents may apply.
3. Rejection is measured as attenuation below the minimum IL point in
the passband. Rejection in final user application is dependent on
PCB layout and external impedance matching design. See Applica-
tion Note No. 42 for details.
8. RFM, stylized RFM logo, and RF Monolithics, Inc. are registered
trademarks of RF Monolithics, Inc.
9. ©Copyright 1999, RF Monolithics Inc.
10. Electrostatic Sensitive Device. Observe precautions for handling.
4. "LRIP" or "L" after the part number indicates "low rate initial produc-
tion" and "ENG" or "E" indicates "engineering prototypes."
RF Monolithics, Inc.
RFM Europe
Phone: (972) 233-2903
Phone: 44 1963 251383
Fax: (972) 387-8148
Fax: 44 1963 251510
E-mail: info@rfm.com
http://www.rfm.com
SF2008D-121604
Page 1 of 4
©1999 by RF Monolithics, Inc. The stylized RFM logo are registered trademarks of RF Monolithics, Inc.