SF2006C
• SAW Filter for W-CDMA
• 5.0 X 5.0 X 1.7 mm Surface-Mount Case
• Complies with Directive 2002/95/EC (RoHS)
190.00 MHz
SAW Filter
Pb
Maximum Rating
Rating
Value
10
Units
dBm
°C
Input Power Level
Operating Temperature Range
Storage Temperature Range in Tape and Reel
-30 to +70
-30 to +70
°C
SM5050-8
Electrical Characteristics
Characteristic
Sym
Notes
Min
Typ
Max
Units
f
Center Frequency
Insertion Loss
190
8.0
5.73
70
MHz
dB
C
IL
10
MIN
6 dB Bandwidth
BW
4.8
MHz
ns
Group Delay Ripple
150
8
RMS Phase Linearity, f ± 2 MHz
6
deg
C
Attenuation Referended to IL
MIN:
170 to 180 MHz, or (f - 20 MHz) to (f - 10 MHz)
27
25
25
27
34
C
C
180 to 185.5 MHz, or (f -10 MHz) to (f -4.5 MHz)
31
C
C
194.5 to 200 MHz, or (f + 4.5 MHz) to (f + 10 MHz)
30
dB
C
C
200 to 210 MHz, or (f + 10 MHz) to (f + 20 MHz)
33
50
C
C
Ultimate Rejection
Lid Symbolization (Y=year, WW=week, S=shift)
RFM 734 YWWS
Electrical Connections
Connection
Terminals
Port 1
Port 2
Input
Output
Ground
2
6
All others
Dot indicates Pin 1
CAUTION: Electrostatic Sensitive Device. Observe precautions for handling.
Notes:
1.
Unless noted otherwise, all specifications apply over the operating temper-
ature range with filter soldered to the specified demonstration board with
impedance matching to 50 Ω and measured with 50 Ω network analyzer.
Unless noted otherwise, all frequency specifications are referenced to the
nominal center frequency, fc.
Rejection is measured as attenuation below the minimum IL point in the
passband. Rejection in final user application is dependent on PCB layout
and external impedance matching design. See Application Note No. 42
for details.
5.
6.
The design, manufacturing process, and specifications of this filter are
subject to change.
Either Port 1 or Port 2 may be used for either input or output in the design.
However, impedances and impedance matching may vary between Port 1
and Port 2, so that the filter must always be installed in one direction per
the circuit design.
US and international patents may apply.
RFM, stylized RFM logo, and RF Monolithics, Inc. are registered
trademarks of RF Monolithics, Inc.
2.
3.
7.
8.
4.
"LRIP" or "L" after the part number indicates "low rate initial production"
and "ENG" or "E" indicates "engineering prototypes."
www.RFM.com E-mail: info@rfm.com
©2008-2010 by RF Monolithics, Inc.
Page 1 of 4
SF2006C - 6/14/10