SF1099A 280 MHz SAW Filter
PRELIMINARY
·
·
·
Designed for WLL Receiver IF
Hermetic 13.3 x 6.5 mm Surface-Mount Case
Unbalanced Input and Output
Characteristic
Nominal Center Frequency
Passband
Sym
fc
IL
Min
Typ
280.000
11
Max
Units Notes
MHz
dB
1
Insertion Loss at fc
14.0
3 dB Passband BW3
Amplitude Ripple over fc ±1100 kHz
Group Delay Variation over fc ±1350 kHz
TBD to fc-2.7 MHz and fc+2.7 MHz to TBD
kHz
dBP-P
nsP-P
dB
1, 2
±1350
±1500
1.0
150
GDV
TA
Rejection
40
-40
1, 2, 3
1
Operating Temperature Range
+85
°C
External L-C
SM13365-12 13.3 x 6.5 mm Nominal Footprint
RFM SF1099A YYWW
Impedance Matching to 50 W unbalanced
Case Style
Lid Symbolization (YY = year, WW = week) See note 4
Absolute Maximum Ratings
Electrical Connections
Rating
Value
+10
30
Units
dBm
VDC
°C
Connection Terminals
Maximum Incident Power in Passband
Max. DC voltage between any 2 terminals
Storage Temperature Range
Max Soldering Profile
Port 1 Hot
Port 1 Gnd Return
Port 2 Hot
2
3
8
9
-40 to +85
Port 2 Gnd Return
265°C for 10 s
Case Ground All others
Notes:
1. Unless noted otherwise, all specifications apply over the operating temperature range with filter soldered to the specified
demonstration board with impedance matching to 50 W and measured with 50 W network analyzer.
2. Unless noted otherwise, all frequency specifications are referenced to the nominal center frequency, fc.
3. Rejection is measured as attenuation below the minimum IL point in the passband. Rejection in final user application is dependent
on PCB layout and external impedance matching design. See Application Note No. 42 for details.
4. “LRIP” or “L” after the part number indicates “low rate initial production” and “ENG” or “E” indicates “engineering prototypes.”
5. The design, manufacturing process, and specifications of this filter are subject to change.
6. Either Port 1 or Port 2 may be used for either input or output in the design. However, impedances and impedance matching may
vary between Port 1 and Port 2, so that the filter must always be installed in one direction per the circuit design.
7. US and international patents may apply.
8. RFM, stylized RFM logo, and RF Monolithics, Inc. are registered trademarks of RF Monolithics, Inc.
9. ã Copyright 1999, RF Monolithics Inc.
10. Electrostatic Sensitive Device. Observe precautions for handling.
RF Monolithics, Inc.
4347 Sigma Road
Dallas, Texas 75244
USA
Phone: +1(972)233-2903
Fax: +1(972)387-8148
e-mail: info@rfm.com
European Sales Office
44 1963 251383
44 1963 251510
Home page: www.rfm.com
SF1099A 7/14/1999 R