Description
Features
The SE3362 is a charge pump operating in either
1x mode or 2x fractional mode regulating current
through each of the 4 LED pins. Operation at a fixed
high frequency of 1MHz typical allows the use of
very small value ceramic capacitors.
¾
¾
¾
¾
¾
¾
¾
¾
¾
¾
Drives individually up to 4 LEDs
Output current up to 30mA per LED
Digital control On/Off of each LED
Compatible with supply voltage of 2.85V to 5.5V
Power efficiency up to 90%
The SE3362 drives white light-emitting diodes
(LED’s) connected in parallel and provides tightly
matched regulated current to achieve uniformity of
brightness in LCD backlighting applications. An
external resistor RSET controls the output current
level. LED currents of up to 30mA are supported
over a range of input supply voltages from 2.85V to
5.5V, making the device ideal for battery-powered
applications.
2 modes of operation 1x and 2x
Automatic short circuit detect/disable
High-frequency Operation at 1MHz
Low value ceramic capacitors
Automatically switch to power save mode if no
LED is deteted to be connected to the IC
Thin QFN 16-lead package, 3×3mm
100% Lead (Pb)-Free
¾
¾
LED dimming can be accomplished by several
methods including using a resistor Rset (the exact
Application
¾
¾
¾
¾
¾
¾
Color LCD and keypad Backlighting
formula will
be provided in the Application
Cellular Phones
Handheld Devices
Digital Cameras
PDAs
Section) to set the RSET pin current, applying a
PWM signal on the Control signals, or adding a
switched resistor in parallel with Rset. The Enable
input pin allows the device to be placed in
power-down mode with close to "zero” quiescent
current. The SE3362 features short circuit and Over
Temperature Protection (OTP). The device is
available in a 16- lead thin QFN package with a max
height of 0.8mm.
Portable MP3 players
Application Diagram
Revision 12/4/2008
Preliminary and all contents are subject to change without prior notice
© Seaward Electronics, Inc., 2007. • www.seawardinc.com.cn • Page 1