Single Phase Kilowatt-hour Metering IC
SA2102D
sames
FEATURES
+
Meets the IEC 61036 Specification requirements for
Class 1 AC static watt-hour meters for active energy
Less than 0.5% Error over a dynamic range of 1:1000
The motor drive outputs (MOP, MON) provide the average
power information and can drive an electro-mechanical
counter directly
+
+
+
+
+
+
Bi-directional and uni-directional energy measurement
Configurable for different meter ratings
+
+
Precision on-chip oscillator (70ppm/°C drift)
Precision on-chip voltage reference (10ppm/°C drift)
On-chip anti-creep function (0.02% of Imax)
Low power consumption (<25mW typical)
+
LED pulse output for calibration purposes
DESCRIPTION
The SAMES SA2102D* is an accurate single phase
power/energy metering integrated circuit providing a single-
chip solution for energy meters. Very few external components
are required and has direct drive capability for electro
mechanical counters. The SA2102D does not require an
external crystal. A precision oscillator, which supplies the
circuitry with a stable frequency, is integrated on chip. The
SA2102D metering integrated circuit generates a pulse rate
output, the frequency of which is proportional to the power
consumption. The SA2102D performs the calculation for
active power. The method of calculation takes the power factor
into account.
(IMAX) and nominal voltages (VNOM) without having to change
the stepper motor or impulse counter gear ratio. The LED pulse
output follows the average power consumption measured and
is intended for meter calibration purposes. In fast calibration
mode this output provides a high frequency pulse rate following
the instantaneous power consumption and can be used for fast
calibration or to interface with a microcontroller. The SA2102D
includes an anti-creep feature preventing any creep effects in
the meter. The SA2102D can be configured for positive,
negative or bi-directional energy measurement.
The SA2102D integrated circuit is pin compatible to the
SA2002D and is available in 20 pin dual-in-line plastic
(PDIP20), as well as 20 pin small outline (SOIC20) package
types.
Programmable inputs allow the meter manufacturer to
configure the SA2102D for different meter maximum currents
VDD
SO
DIRI
DIRO
FAST
POWER ON
RESET
DIGITAL
OUTPUT
IIP
IIN
SIGNAL
PROCESSING BLOCK
ADC
Instantaneous
power
DIVISION
FOR
CALIBRATION
LED OUTPUT
Average
Power
LED
R0
INTEGRATION
IVP
DIGITAL
OUTPUT
ADC
AGND
R1
R2
DIVISION
FOR
COUNTER DRIVER
VOLTAGE REFERENCE
AND
CURRENT BIASING
OSCILLATOR
AND
TIMING
MOTOR
DRIVING
BUFFERS
VSS
CNF
MON
MOP
VREF
Figure 1: Block diagram
* Patents EP0559499, US5396447, PT559499T, ZA9301579, ZA9400273, ZA9702075
http://www.sames.co.za
1/16
SPEC-0510 (REV. 5)
12-02-03