Preliminary
RT9702/A
80mΩ, 500mA/1.1A High-Side Power Switches with Flag
General Description
Features
The RT9702 and RT9702A are cost-effective, low
voltage, single N-Channel MOSFET high-side power
switches, optimized for self-powered and bus-
powered Universal Serial Bus (USB) applications.
The RT9702/A equipped with a charge pump
circuitry to drive the internal MOSFET switch; the
switch’s low RDS(ON), 80mΩ, meets USB voltage drop
requirements; and a flag output is available to
indicate fault conditions to the local USB controller.
ꢁ Compliant to USB Specifications
ꢁ Built-In (Typically 80mΩ) N-Channel MOSFET
ꢁ Output Can Be Forced Higher Than Input
(Off-State)
ꢁ Low Supply Current:
25µA Typical at Switch On State
0.1µA Typical at Switch Off State
ꢁ Guaranteed 500mA/RT9702 and 1.1A/RT9702A
Continuous Load Current
ꢁ Wide Input Voltage Ranges: 2V to 5.5V
ꢁ Open-Drain Fault Flag Output
ꢁ Hot Plug-In Application (Soft-Start)
ꢁ 1.7V Typical Under-Voltage Lockout (UVLO)
ꢁ Current Limiting Protection
Additional features include soft-start to limit inrush
current during plug-in, thermal shutdown to prevent
catastrophic switch failure from high-current loads,
under-voltage lockout (UVLO) to ensure that the
device remains off unless there is a valid input
voltage present, fault current is limited to typically
800mA for RT9702 in single port and 1.5A for
RT9702A in dual ports in accordance with the USB
power requirements, lower quiescent current as
25µA making this device ideal for portable
battery-operated equipment.
ꢁ Thermal Shutdown Protection
ꢁ Reverse Current Flow Blocking (no “body
diode)
ꢁ Smallest SOT-25 Package Minimizes Board
Space
ꢁ UL Approved – E219878
The RT9702/A is available in SOT-25 package
requiring minimum board space and smallest
components.
Applications
ꢁ USB Bus/Self Powered Hubs
ꢁ USB Peripherals
ꢁ ACPI Power Distribution
ꢁ PC Card Hot Swap
ꢁ Notebook, Motherboard PCs
ꢁ Battery-Powered Equipment
ꢁ Hot-Plug Power Supplies
ꢁ Battery-Charger Circuits
Ordering Information
RT9702/A ꢀꢀ
Package Type
B : SOT-25
Operating Temperature Range
C: Commercial Standard
Pin Configurations
1.1A Output Current
Part Number
Pin Configurations
500mA Output Current
TOP VIEW
RT9702/ACB
(Plastic SOT-25)
1. CE
5
1
4
2. GND
3. FLG
4. VIN
5. VOUT
Marking Information
For marking information, contact our sales
representative directly or through a RichTek
distributor located in your area, otherwise visit our
website for detail.
3
2
DS9702A-01
March 2003
www.richtek.com
1