RT9012
300mA Dual LDO Regulator with POR
General Description
Features
z Wide Operating Voltage Ranges : 2.5V to 5.5V
RT9012 is a dual channel, low noise, and low dropout with
the sourcing ability up to 300mA and power-on reset
function. The range of output voltage is from 1.2V to 3.6V
by operating from 2.5V to 5.5V input.
z Low-Noise for RF Application
z No Noise Bypass Capacitor Required
z Fast Response in Line/Load Transient
z TTL-Logic-Controlled Shutdown Input
z Low Temperature Coefficient
The RT9012 offers 2% accuracy, extremely low dropout
voltage (240mV @ 300mA), and extremely low ground
current, only 27uA per LDO. The shutdown current is near
zero current which is suitable for battery-power devices.
Other features include current limiting, over temperature,
output short circuit protection.
z Dual LDO Outputs (300mA/300mA)
z Ultra-low Quiescent Current 27uA/LDO
z High Output Accuracy 2%
z Short Circuit Protection
z Thermal Shutdown Protection
The RT9012 is short circuit thermal folded back protected.
The IC lowers its OTP trip point from 165°C to 110°C when
output short circuit occurs (VOUT < 0.4V) providing
maximum safety to end users.
z Current Limit Protection
z Short Circuit Thermal Folded Back Protection
z Tiny 8-Lead WDFN Package
z RoHS Compliant and 100% Lead (Pb)-Free
The RT9012 can operate stably with very small ceramic
output capacitors, reducing required board space and
component cost. The RT9012 is available in fixed output
voltages in the WDFN-8L 2x2 package.
Applications
z CDMA/GSM Cellular Handsets
z Battery-Powered Equipment
z Laptop, Palmtops, Notebook Computers
z Hand-Held Instruments
Ordering Information
RT9012-
z PCMCIA Cards
Package Type
QW : WDFN-8L 2x2 (W-Type)
z Portable InformationAppliances
Lead Plating System
P : Pb Free
G : Green (Halogen Free and Pb Free)
Pin Configurations
(TOP VIEW)
1
2
3
4
8
7
6
5
VOUT1
VOUT2
POR
VIN
EN1
EN2
SET
Output Voltage : VOUT1/VOUT2
VOUT2 > VOUT1 is Recommended
9
GND
Note :
WDFN-8L 2x2
Richtek products are :
Available Voltage Version
` RoHS compliant and compatible with the current require-
ments of IPC/JEDEC J-STD-020.
` Suitable for use in SnPb or Pb-free soldering processes.
Code Voltage Code Voltage Code Voltage
A
D
G
K
N
R
V
Y
3.5
1.85
1.8
B
E
H
L
1.3
2.1
2
C
F
1.2
1.5
Marking Information
J
2.5
For marking information, contact our sales representative
directly or through a Richtek distributor located in your
area.
2.6
2.7
3
M
Q
T
2.8
2.85
3.2
P
S
W
3.1
3.3
1.6
2.65
3.15
2.9
X
1.9
DS9012-09 April 2011
www.richtek.com
1