RT1650
Wireless Power Receiver Compliant with WPC
General Description
The RT1650 is a wireless power receiver compliant
High Accurate Received Power Calculation for
FOD Function
with WPC V1.1 standard. The RT1650 integrates a
synchronous full-bridge rectifier,
a
low dropout
10-bit ADC for Voltage/Current Measurement
Coil Power Loss Modeling for Optimized
Compensation
regulator, and a Micro Controller Unit (MCU) for control
and communication. The device receives AC power
from a WPC compatible wireless transmitter and
provides output power up to 7.5W, which could be used
as a power supply for a charger of mobile or consumer
devices.
Adaptive Power Offset Compensation
Low Quiescent Embedded 32-bit ARM Cortex-M0
MCU
32KB ROM/OTP, 1KB SRAM and 272B MTP
Easy Tuning for Communication and Control
Parameters
The MCU-based controller can support bi-direction
channel communication including Frequency Shift
Keying (FSK) demodulation for power signal from the
transmitter and Amplitude Shift Keying (ASK)
modulation for power signal to the transmitter. The
RT1650 provides Foreign Object Detection (FOD)
function to meet the requirement after WPC V1.1. It
communicates with the transmitter for the received
power to determine if a foreign object is present within
the magnetic interface. This provides a higher level of
safety.
Support Bi-direction Channel Communication
FSK Demodulation for Power Signal from
Wireless Power Transmitter
ASK Modulation for Power Signal to Wireless
Power Transmitter
Programmable Temperature Control
Programmable Charge Status Packet
Support Alignment with Transmitter
Support Enable, Charge Complete and Fault
Control Inputs
The RT1650 provides a programmable dynamic
rectifier voltage control function to improve power
efficiency, a programmable power management control
for maximum power delivery, a programmable current
limit for suitable load setting, a programmable temperature
setting with external NTC for thermoregulation, and
proper protection functions such as UVLO, OVP, and
OTP.
Receiver Controlled EPT Packet
Over Current Limit
Over Voltage Protection
Thermal Shutdown
CSP 3.0mm x 3.4mm 48B (Pitch = 0.4mm)
Low Profile (0.5mm Max.)
Applications
WPC Compliant Receivers
Cell Phones & Smart Phones
Digital Cameras
Features
Single-Chip WPC V1.1 Compliant Receiver
Integrated Synchronous Rectifier Switch
Support Output Power up to 7.5W
High Rectifier Efficiency up to 96%
High System Efficiency up to 80%
Programmable Loading for Synchronous Rectifier
Operation
Power Banks
Wireless Power Embedded Batteries
Headsets
Portable Media Players
Hand-held Devices
Programmable Dynamic Rectifier Voltage Control
for Optimized Transient Response and Power
Efficiency
Copyright © 2015 Richtek Technology Corporation. All rights reserved.
is a registered trademark of Richtek Technology Corporation.
DS1650-00 July 2015
www.richtek.com
1