RS6-R30
3.0 Watt regulated
single output
■
■
■
■
■
12 Pin SIP12 package
1000 VDC isolation up to 3000 VDC isolation
Continuous short circuit protection
Efficiency up to 71%
-25°C~71°C operation temperature range
SIL 12 package, pic. similar
OUTPUT SPECIFICATIONS
Voltage accuracy
Line regulation
Load regulation (From 0% to 100% Load)
(3.3 V output model)
ABSOLUTE MAXIMUM RATINGS (4)
These are stress ratings. Exposure of devices to any of these
conditions may adversely affect long-term reliability.
Input voltage (100 mS)
2%
0.5%
0.5%
1.5%
5 modes
12 modes
24 modes
0 ~ 7 VDC
0 ~ 15 VDC
0 ~ 28 VDC
260°C
Ripple & Noise (20 MHz bandwith) (1)
75 mV pk-pk
Short circuit protection
Temperature coefficient
Capacitor load (2)
Indefinite (automatic recovery)
0.02%/°C
Lead soldering temperature
See table
(1.5 mm from case 10 sec.)
INPUT SPECIFICATIONS
Voltage range
Max. input current
No-load input current
Input filter
All specifications typical at Ta = 25°C, nominal input voltage and full load
unless otherwise specified.
The information and specifications contained in this data sheet are believed
to be correct at time of publication. However, we accept no responsibility
for consequences arising from printing errors or inaccuracies.
Subject to change without notice.
10%
See table
See table
Capacitors
20 mA pk-pk
Input reflected ripple current (3)
GENERAL SPECIFICATIONS
NOTE
Efficiency
I/O isolation voltage (3 sec.)
Input / output
I/O isolation capacitance
I/O isolation resistance
Switching frequency
Humidity
Reliability calculated MTBF (MIL-HDBK-217F)
Safety standard (designed to meet)
See table
1) Ripple / Noise measured with 20 MHz bandwith.
2) Tested by minimal Vin and constant resistive load.
3) Measured input reflected ripple current with a simulated
source inductance of 12uH.
4) Exceeding the absolute ratings of the unit could cause
damage. It is not allowed for continuous operating.
5) Operation under no-load conditions will not damage
these devices. However they may not meet all listed
specifications.
1000 ~ 3000 VDC
60 pF typ.
1000 M Ohm
50 kHz typ.
95% rel. H
> 1.12 Mhrs.
IEC 60950-1
PHYSICAL SPECIFICATIONS
Case material
Non-conductive black plastic
(UL94V-0 rated)
Pin material
Potting material
Weight
0.5 mm Alloy42 solder-coated
Epoxy (UL94V-0 rated)
7.2 g
The models listed are just for standard type. If you need a
special specification product, please contact our service.
Phone: +49 69 984047-0, mail to: info@rsg-electronic.de
or use the forms on www.rsg-electronic.de („Kontakt“).
Dimensions
1.26“ x 0.32“ x 0.57“
ENVIRONMENT SPECIFICATIONS
Operating temperature
-25°C~ 71°C
(See derating curve)
100°C
-40°C~125°C
Nature convection
Maximum case temperature
Storage temperature
Cooling
Page: 1/3
Last update: 18.02.09