Preliminary Product Brief *
For Discussion with Tyco Electronics Customers Only – Tyco Electronics Proprietary
Phone: 800-253-0490
Fax: 408-732-2002
www.xp-foresight.com
QRW 40A single output series
Industry standard Quarter brick DC/DC converter,
36Vdc-75Vdc (48V) input voltage range,
Output voltages available from 12V-1.0V
·
·
·
Delivers up to 40A output current
Ultra High Efficiency: 91% @ 3.3V full load
Improved Thermal Performance:
25A at 70°C at 1ms-1 (200LFM)
·
·
High power density: 100W/in³
Low output voltages down to 1V:
supports migration to future IC and
microprocessor supply voltages
·
·
Active load sharing option: Paralleling
Cost efficient open frame design
I
II
III
IV
·
Optional heat-sink: to permit operation
(approval pending)
over extended ambient temperature ranges
The QRW-series dc-dc converters are
a
new
Specification
generation of DC/DC power modules designed for
optimum efficiency and power density. The QRW
provides up to 40A output current in an industry
standard quarter brick, which makes it an ideal choice
for small space, high current and low voltage
applications. The converter uses synchronous
rectification technology and innovative packaging
techniques to achieve ultra high efficiency reaching
91% at 3.3V full load. Thanks to the ultra high
efficiency of this converter, the power dissipation is
such that for most applications a heat sink is not
required. In addition, the QRW-series supports future
migration of semiconductor and microprocessor supply
voltages down to 1.0V.
·
·
·
·
·
·
·
Tightly regulated output, typical ±1%
Monotonic start-up into pre-biased output
Output voltage adjustment trim +10% / -20%
Load regulation ± 0.2%
Line regulation ± 0.2%
No minimum load required
Ripple and noise (5Hz to 20MHz bandwidth)
– RMS 40mVrms (3.3V)
– Peak to peak 150mVpk-pk (3.3V)
Operating temperature range: -40°C to 110°C
Designed to meet basic insulation
1500Vdc isolation voltage
·
·
·
·
Remote output voltage sensing
Protection
·
·
·
Output overcurrent and overvoltage protection
Over-temperature protection
Input under voltage protection
Applications
Options
·
·
·
·
Wireless Networks
·
·
·
·
Positive remote on/off logic
Access and Optical Network Equipment
Enterprise Networks
Latest generation ICs (DSP, FPGA, ASIC)
and Microprocessor powered applications
Active load sharing (Paralleling)
Case ground pin
Auto restart after fault shutdown
·
Heatsink
I)
II)
This product is intended for integration into end-use equipment. All the required procedures for CE marking of end-use equipment should be followed.
CSA is a registered trademark of Canadian Standards Association.
III) UL is a registered trademark of Underwriters Laboratories, Inc.
IV) VDE is a trademark of Verband Deutcher Elektrotechniker e.V.