Technical
Specification
PQ60010QPA60
48Vin 1.0Vout 60Amp 2000Vdc
Quarter-brick
DC/DC Converter
Input
Output
Current
Isolation
®®
The PQ60010QPA60 PowerQor Peta quarter-brick converter
is a next-generation, board-mountable, isolated, fixed
switching frequency DC/DC converter that uses synchronous
rectification to achieve extremely high conversion efficiency.
The power dissipated by the converter is so low that a
heatsink is not required, which saves cost, weight, height, and
application effort. AAll of the power and control components
are mounted to the multi-layer PCB substrate with high-yield
surface mount technology. SSince the PowerQor converter has
no explicit thermal interfaces, it is extremely reliable. The Peta
series offers industry leading output currents for any standard
quarter-brick module. RoHS compliant (see page 13).
PQ60010QPA60 Module
Operational Features
• Ultra-high efficiency, 86% half load, 83% full load
• Delivers up to 60 amps of output current with minimal
Protection Features
derating - no heatsink required
• Input under-voltage lockout disables converter at low
input voltage conditions
• Output current limit and short circuit protection protects
converter and load from permanent damage and
consequent hazardous conditions
• Wide input voltage range: 36V – 75V, with 100V
100ms input voltage transient capability
• Fixed frequency switching provides predictable EMI
performance
• No minimum load requirement means no preload
resistors required
• Active back bias limit prevents damage to converter
from external load induced pre-bias
• Output over-voltage protection protects load from
damaging voltages
Mechanical Features
• Thermal shutdown protects converter from abnormal
• Industry standard quarter-brick pin-out configuration
• Industry standard size: 1.45” x 2.3” (36.8x58.4mm)
environmental conditions
• Total height less than 0.45” (11.4mm), permits better
Safety Features
airflow and smaller card pitch
• Total weight: 1.5 oz. (42 grams)
• UL 60950-1:R2011-12
• EN60950-1/A12:2011
• CAN/CSA-C22.2 No. 60950-1/A1:2011
• Flanged pins designed to permit surface mount
soldering (avoid wave solder) using FPiP technique
Control Features
• On/Off control referenced to input side (positive and
negative logic options are available)
• Remote sense for the output voltage compensates for
output distribution drops
• Output voltage trim permits custom voltages and
voltage margining
Product # PQ60010QPA60
Phone 1-888-567-9596
www.synqor.com
Doc.# 005-2QP610F Rev. F
10/02/2013
Page 1