Technical
Specification
PQ60015EML15
48Vin 1.5Vout 15Amp 2000Vdc
Eighth-brick
DC/DC Converter
Input
Output
Current
Isolation
®
The PQ60015EML15 PowerQor Mega eighth-brick con-
verter is a next-generation, board-mountable, isolated, fixed
switching frequency DC/DC converter that uses synchro-
nous rectification to achieve extremely high conversion effi-
ciency. The power dissipated by the converter is so low
that a heatsink is not required, which saves cost, weight,
height, and application effort. All of the power and control
components are mounted to the multi-layer PCB substrate
with high-yield surface mount technology.
Since the
PowerQor converter has no explicit thermal interfaces, it is
extremely reliable. RoHS compliant (see page 12).
PQ60015EML15 Module
Operational Features
• High efficiency, >85% at full rated load current
• Delivers up to 15 amps of output current with minimal
Protection Features
derating - no heatsink required
• Wide input voltage range: 35V – 75V, with 100V
100ms input voltage transient capability
• Input under-voltage lockout disables converter at low
input voltage conditions
• Output current limit and short circuit protection protects
converter and load from permanent damage and conse-
quent hazardous conditions
• Fixed frequency switching provides predictable EMI
performance
• No minimum load requirement means no preload
resistors required
• Active back bias limit prevents damage to converter
from external load induced pre-bias
• Output over-voltage protection protects load from dam-
aging voltages
Mechanical Features
• Thermal shutdown protects converter from abnormal
• Industry standard eighth-brick pin-out configuration
• Industry standard size: 0.90” x 2.3” (22.9x58.4mm)
environmental conditions
• Total height only 0.335” (8.5mm), permits better airflow
and smaller card pitch
• Total weight: 0.68 oz. (19 grams)
Safety Features
• 2000V, 30 MΩ input-to-output isolation provides
• Flanged pins designed to permit surface mount solder-
input/output ground separation
ing (avoid wave solder) using FPiP technique
• UL 60950-1 recognized (US & Canada), basic insula-
tion rating
• TUV certified to EN60950-1
Control Features
• Meets 72/23/EEC and 93/68/EEC directives which
• On/Off control referenced to input side (positive and
negative logic options are available)
facilitates CE Marking in user’s end product
• Board and plastic components meet UL94V-0 flammabil-
ity requirements
• Remote sense for the output voltage compensates for
output distribution drops
• Output voltage trim permits custom voltages and voltage
margining
Product # PQ60015EML15
Phone 1-888-567-9596
www.synqor.com
Doc.# 005-2EM651E Rev. D
10/15/10
Page 1